0
What else can I help you with?
What should I do if my diagnostics of my 1991 dodge stealth rt say that the fuel circuit is bad?
You should replace your fuel circuit..
What should you do to the surge strip if the circuit breaker fails to reset?
You should replace the surge strip if the circuit breaker fails to reset.
What should I do if I have a burned circuit breaker in my home?
If you have a burned circuit breaker in your home, it is important to turn off the power to that circuit immediately and contact a licensed electrician to inspect and replace the damaged breaker. Do not attempt to fix or replace the breaker yourself as it can be dangerous.
What should you do if your circuit breaker is hot?
You should check that you are not running too many appliances on the circuit that is protected by the circuit breaker.If you are absolutely sure that the circuit is not being overloaded, you should replace the breaker with a new identical breaker. Breakers get hot when they supply power at near peak amperage over a long period of time and begin to break down internally.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
On a humid day the PLASTIC part of the light switch in your bathroom lights up a power tester It's 240 volts Is this dangerous?
the plastic part of the light switch should never show voltage especially if it's a 120 volt circuit. 240 volts is two 120 volt circuits the circuit might be connected to another circuit in the bathroom separating them will fix the voltage but you should also inspect and replace the switch. Chris Belveal
Can you replace P185 65R15 tires with P195 60R15 tires in a 2007 Prius?
Should not be a problem. Tires have an almost identical height so speedometer will remain accurate.
What is a brown fuse and why should you never replace one with a penny?
I believe the question should be what is a BLOWN fuse and why should you never replace it with a penny? A blown fuse would be one that has been over stressed and has burnt out or blown out to protect the wiring or other part of the circuit. A penny would bypass the fuse which is the safety measure in the circuit. Bypassing a fuse could cause a fire or serious damage to the device.
When a fuse blows?
When a fuse blows, you should replace the fuse and check to see what might have caused it to blow. It's a sign that there might be something causing too much current to flow in the circuit.
Can you replace 2.5 Amps 125 Volts with 10 Amps 125 Volts?
You physically can but sit will be unsafe, and will not protect the circuit because it will not blow when it should. Only replace a fuse with the same size fuse.
What is the key difference between a parallel circuit and a series circuit?
A series circuit pretty much runs in one direction, with each item which uses a load on that circuit one after another in a series. Should one load go out (a lamp, for example) then the entire series is defunct. A parallel circuit has more than one way to run, has a parallel or tandem circuit, so that if one load (our lamp, again) should fail, the electricity has another path (or more) to get to other loads on the circuit.
What suspension from another car could be used on a 1992 crown Victoria?
1992 to 1997 should all be the same. The 1992-97 Mercury Grand Marquis should also be identical.
How are cells similar?
They should be identical.
