The voltage measured across an open in a series circuit is the equivalent of the sourse voltage.
Supplied voltage.
No one is going to be able to tell you that. You are looking for the measured voltage, so go and measure it. In any case, if you were just looking for the voltage it will depend on the circuit current. You can work it out using ohms law (Voltage = Current * Resistance).
there is 120V across the circuit.
The voltage drop across each resistor is determined by the amounts of resistance in the 3 resistors and all the rest of the resistances in the electrical circuit.
Well, you should really measure the open-circuit voltage and the short circuit current both under dark and light conditions and then compare them to fully characterize a solar cell. Measuring the open-circuit voltage means measuring the voltage across the cell when no current is flowing (i.e., with a LARGE resistance as a load on the cell). Measuring the short-circuit current means measuring the current when the voltage across the circuit is essentially zero (i.e., with a VERY SMALL resistance as a load on the cell--thus, "short-circuit" current).
voltage is devided only in series circuit and is the same at the parallel circuit
The full circuit voltage
It's measured with an AC voltmeter.
In both cases, the power dissipated is measured by multiplying the voltage across the circuit by the current through the circuit.
In both cases, the power dissipated is measured by multiplying the voltage across the circuit by the current through the circuit.
Voltage is impressed across a circuit. Current flows through a circuit.
How does the voltage measured across a dry cell ompare with the voltage drop measured across three bulbs in series?
No one is going to be able to tell you that. You are looking for the measured voltage, so go and measure it. In any case, if you were just looking for the voltage it will depend on the circuit current. You can work it out using ohms law (Voltage = Current * Resistance).
The source of electrons in a circuit is supplied by an electric potential difference across two points . This potential difference in a circuit is called as voltage and is measured in joules per coulomb or volts.
there is 120V across the circuit.
In a parallel circuit the voltage across each component is the same.
The voltage drop across each resistor is determined by the amounts of resistance in the 3 resistors and all the rest of the resistances in the electrical circuit.
there is 120V across the circuit.