An Oasis Prong.
The horizontal dimensions of the container ... like length and width ... don't make any difference. But the pressure at the bottom is directly proportional to the depth of the liquid, which is ultimately limited by the height of the container.
'''''Decantation''''' is a fast method for separating a mixture of a liquid and a heavier solid. In this process , first the solid impurities are allowed to sediment at the bottom of the container. Then, the pure liquid is poured out carefully from the container into another container. The precipitate or solid is left behind at the bottom of the container.
This question does not provide enough information on the relevant parameters to even attempt an answer. One would assume that if the hole is at the bottom of the container (and not on the side at the bottom) and the liquid is coming out of the hole only due to gravity that the the container would remain stationary. If there is internal pressure in the container, then the initial pressure becomes important as does the time since the water began to flow. If the hole is on the side of the container, then friction between the container and the surface it is resting on become significant. If the container is not circular in cross section, then the location of the hole along the side helps determine whether the container moves laterally or spins.
No. The particles in a gas spread out and completely fill their entire container, regardless of the shape or volume of the container.
Centrifuge
Denser particles would move towards the bottom of the container due to centrifugal force.
it is molting
Sometimes a warm bath will help if they are constipated. Fill the tub or container with just enough warm water to go to the bottom of his armpits.
well here: DO YOUR HW ALONE
The horizontal dimensions of the container ... like length and width ... don't make any difference. But the pressure at the bottom is directly proportional to the depth of the liquid, which is ultimately limited by the height of the container.
'''''Decantation''''' is a fast method for separating a mixture of a liquid and a heavier solid. In this process , first the solid impurities are allowed to sediment at the bottom of the container. Then, the pure liquid is poured out carefully from the container into another container. The precipitate or solid is left behind at the bottom of the container.
Place container (3) beside container (6) at the bottom Place container (2) above the other container (3) place it in middle Left most pipe (2) route it with elbows until the down pipe then place a right elbow to fill container (3) at the bottom 2nd pipe (2) place a left elbow to fill container (2) 3rd pipe (3) place a left elbow to fill the container below container (2) pipe (1) elbow around the right side to reach the middle to fill bottom container (3)
Putting a piece of bread in the center (or bottom) of the container sometimes helps to keep baked goods fresh.
Syrup and water do not mix so the syrup drops directly down to the bottom because it is a heavier, and thicker substance than water, so therefore will sink to the bottom of the container.
Edible Arrangements sells a vast array of beautiful fruit and chocolate bouquets for every occasion. Some of these items can get quite expensive, but at the bottom of the scale, they have a box of strawberries dipped in chocolate for $29.
This question does not provide enough information on the relevant parameters to even attempt an answer. One would assume that if the hole is at the bottom of the container (and not on the side at the bottom) and the liquid is coming out of the hole only due to gravity that the the container would remain stationary. If there is internal pressure in the container, then the initial pressure becomes important as does the time since the water began to flow. If the hole is on the side of the container, then friction between the container and the surface it is resting on become significant. If the container is not circular in cross section, then the location of the hole along the side helps determine whether the container moves laterally or spins.
It is the container on the bottom of the engine.