yes
In parallel ckt voltage in all branches will be same, its different in series ckt
Transformers can be connected in parallel, if they have the same primary and secondary voltages and equal operating frequency.
Parallel. Coz all the elements will get same voltages from the sources. in case of series connection, the voltage is divided between all elements.
They are not. They are connected differently, and the voltages and currents behave in different ways.
They are not. They are connected differently, and the voltages and currents behave in different ways.
Because millman's is used in parallel ckt of impedances and voltage sources
Kirchof's Law - the voltages are measured between the same starting-point and end-point.
A parallel circuit. Since a parallel circuit has only two nodes, there can be only one voltage difference between the nodes.
Short answer: By using a varactor diode as the capacitance in a parallel resonant ckt, by changing the reverse bias voltage you change the value of capacitance which in turn changes the resonant frequency. This makes a tuneable resonant ckt.
If they are at the same voltage, and the same kW, the only thing left that will influence the output amperage is the power factor the generator is running at.
voltage is devided only in series circuit and is the same at the parallel circuit
To parallel two synchronous generators, they must have the same voltage, frequency, and phase sequence. Additionally, their terminal voltages must be in phase alignment, their frequencies must be the same, and their voltages must be within an acceptable range of each other. Proper synchronization is crucial to avoid phase differences and ensure smooth parallel operation.