Want this question answered?
this is for a 2002 doge durango, it must be the sameLOCK CYLINDERREMOVALThe ignition key must be in the key cylinder for cylinder removal.# Disconnect negative cable from battery. # Remove upper and lower covers (shrouds) from steering column. # Place shifter in PARK position.# A retaining pin (Fig. 9) is located at side of key cylinder assembly. # Rotate key to RUN position. # Press in on retaining pin while pulling key cylinder from ignition switch.INSTALLATIONThe ignition key must be in the key cylinder for cylinder installation.# Install the key cylinder into the housing using care to align the end of the key cylinder with the ignition switch. # Push the key cylinder in until it clicks. # Replace the upper and lower shrouds. # Reconnect the battery.
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
The key is good for a single installation.
The Touareg car is an SUV produced by Volkswagon. The main benefits of this vehicle is that its the size of an SUV but the gas mileage of a small car.
Well if the sterring wheel is in a hard left or right position it will be hard to turn the key now. if there is a problem with the cylinder you will have to take it to your local dealer and have the cylinder and have key and remotes reprogramed
You normally do not have to reprogram the key when you replace the battery. If you do you will have to contact your VW dealer.
remove the sttering column shroud. put the key in and turn it to the run position. on the botton of the column where the cylinder goes in there is a button that has to be pushed. the cylinder will slide out. if the key will not turn, you will have to drill out the button.
Put the key in any door key cylinder and turn.Put the key in any door key cylinder and turn.
http://www.crvownersclub.com/TSBs/2004/03-068.pdf
You first need to remove the plastic trim pieces from around the steering column, then turn your key to the 'on' position and look for a small button underneath the ignition cylinder housing. If you're looking at the cylinder from the passenger's seat, it's at approximately 6 - 7 o'clock. use an awl or other pointed object to push the button in and remove your cylinder by pulling the key toward the passenger's side of the car. Installation is the opposite of removal. thats how you replace the key cylinder not the ignition switch.
key
how to remove key cylinder on 98 sunfire