Want this question answered?
You can use pipe thread sealant aka "Pipe Dope" you can get this at most hardware stores.
Teflon tape can be used on any type of liquid joint. However, it is strictly speaking a lubricant, NOT a sealant, and is a cheap and nasty way of sealing joints. - The proper sealant for any liquid pipe joint is a pipe joint compound such as Whitlam's or Oatey's Blue Joint Compound.
With a wrench
Teflon tape only, no joint compound. Two or three wraps is plenty... Yes agreed, teflon tape will make it easier for repairs in the future
Teflon tape, Hercules Pro dope, pipe joint compound and quick wick , Pipe joint compound without quick quick wick , Blue block ,Teflon paste
Yes, you can. I had this very same question myself a few days ago. In order to answer it, I put a piece of teflon tape in the flame of a propane torch. It shriveled, but did not burn or melt and when I stretched it out, it returned to its original shape. I then made a sweat joint inches from a teflon wrapped joint with no problems. You sure want to be carfeul when doing this though. Teflon gives off extremely toxic gas if you melt it.
Pipe joint compound or Teflon tape
No, teflon tape is not sticky and that's for a good reason. -Most people think of teflon tape as a sealant. However it was originally intended for plumbing use as a sealant AND a lubricant so you can get a tighter connection on the pipe joint.
Yes you can run threaded gas fittings in any wall. Just no mechanical joints, (unions, flared fittings ect.). Just make sure you test the line with air. Our company tests at 20lbs and usually leave it overnight to see if there's a drop. This is plenty because you gas line usally only produces a couple pounds of pressure or less. Use teflon tape and pipe dope on every joint. BEFORE using "Teflon" tape make sure it the type approved for the type of "gas" your using. The white Teflon tape is NOT approved in many places as approved for gas service
Welding, Brazing ,threading with Teflon tape (unless it is gas)
provides added protection from water infiltration
Ground joint unions are used to make new connections to threaded gas piping systems (tapping into an existing gas line).