It is like asking which is heavier, 1000 pounds of feathers or 1000 pounds of steel.
Both are the same weight, and 1000 watts is the same amount of power at 120 volts as 220 or 240 volts.
However, the higher voltages of 220 or 240 volts are more efficient at transmitting electrical power, as a smaller percentage of the power is wasted over the resistance of the power lines for an equal amount of amperage delivered.
If all the components are rated to 220V, yes. Keep in mind that if the appliance was designed for 110V it may arc if 220 is run through it. If you don't know the device can handle 220V, don't run it at 220V. Chances are it was manufactured cleaply and cannot handle the extra voltage.
You can buy a converter.
Is the 220V plug 220V only or 110/220V? (The former will have 3 prongs and the former will have 4) If your case is the latter just use the ground, neutral, and one of the hots. This will give you 120V single phase. If the case is the former you can't get 110V off that plug.
The formula you are looking for is I = W/E.
Sorry, but it is impossible to get 220v (240) from one leg, it has to be two legs as each leg is 120v.
220 volt will use less energy.
If all the components are rated to 220V, yes. Keep in mind that if the appliance was designed for 110V it may arc if 220 is run through it. If you don't know the device can handle 220V, don't run it at 220V. Chances are it was manufactured cleaply and cannot handle the extra voltage.
UK is 220v
120V appliance will not work on 220V. Use an instrument transformer or voltage regulator to adjust the high voltage to the desired level.
You don't, at least, not legally.
85 amp/h you can only use about 60% of that so thats 51 amp/h. 1000w 220v uses 4.6 amps so take 51/4.6 and u can run for about 10 hours
No, 120 v is not enough.
Brazil has a nominal voltage of 220/380V.
You can buy a converter.
This type of a transformer is known as a step up transformer.
You can surely buy one on eBay, yes.
Is the 220V plug 220V only or 110/220V? (The former will have 3 prongs and the former will have 4) If your case is the latter just use the ground, neutral, and one of the hots. This will give you 120V single phase. If the case is the former you can't get 110V off that plug.