Yes a 10 amp fuse can be used to protect a 240 volt circuit. The amperage rating of a fuse is based on the given amperage load of the circuit. The voltage rating on a fuse must match or be higher than the voltage that is applied to the fuse. In other words you can not use a 240 volt fuse on a 277, 347, 480 or 600 volt circuit but it can be used on a 120 volt, Manufactures of switching equipment today make it impossible to interchange different voltage fuses to be installed in higher voltage switches.
Yes, as long as it is rated for 240 volt or higher so that it will not arc when it blows and the 240 volt circuit can handle 10 amperes or more.
The 5 amp fuse has many wattages that it can protect. It depends on the voltage of the circuit that the fuse is protecting. Use the following formula, Watts = Volts x Amps. For example 120 volts x 5 amps = 600 watts, 240 volts x 5 amps = 1200 watts, 480 volts x 5 amps = 2400 watts and 600 volts x 5 amps = 3000 watts.
4800
A 240 volt street light circuit is wired in parallel connections. In the base of the street fixture an inline fuse is connected into the circuit that goes up to the fixture to protect the lamp head.
240
No, a 240 volt device runs on 240, and a 120 volt device runs on 120. Attempting to run a device on incompatible voltage results in damage.
3000 divided by 240 approx 13 amps?
Both legs of a 240 branch circuit need to be fused with a fuse rated at 240 volts or better. The voltage potential across the load is what governs the fuse voltage ratings.
Current (amps) = power (watts) / voltage = 100/240 = 0.42 amps
The 5 amp fuse has many wattages that it can protect. It depends on the voltage of the circuit that the fuse is protecting. Use the following formula, Watts = Volts x Amps. For example 120 volts x 5 amps = 600 watts, 240 volts x 5 amps = 1200 watts, 480 volts x 5 amps = 2400 watts and 600 volts x 5 amps = 3000 watts.
A fuse rated for 250 v is fine for 240 v. The fuse might be a cartridge fuse, so it must fit the available socket, or it might be fuse wire that has to be fitted in the holder correctly.
No. The 240V lamp will pop the circuit or fuse because the draw is higher than the supply.
A bright flash and a dud bulb, possibly a blown fuse instead.
4800
A 240 volt street light circuit is wired in parallel connections. In the base of the street fixture an inline fuse is connected into the circuit that goes up to the fixture to protect the lamp head.
240
120 Watts in a 120 Volt system and 240 Watts in a 240 volt 1 phase system and 415 watts in a 240 Volt 3 phase system.AnswerThe SI unit for electric current, the ampere, is defined as 'that constant current which, if maintained in each of two, straight, parallel conductors of infinite length and negligible cross-sectional area, and placed one metre apart in a vacuum, would produce between them a force of 2 x 10-7 newtons per unit length'.
The replacement fuse must be of the same amperage as the one it is replacing. The voltage does not come into play in this application.