The 5 amp fuse has many wattages that it can protect. It depends on the voltage of the circuit that the fuse is protecting. Use the following formula, Watts = Volts x Amps. For example 120 volts x 5 amps = 600 watts, 240 volts x 5 amps = 1200 watts, 480 volts x 5 amps = 2400 watts and 600 volts x 5 amps = 3000 watts.
Without also knowing the voltage of the circuit no answer can be given.
If it is then it has a 3 or 5 amp fuse. Some are not.
The answer depends entirely on the wattage of bulb used! You can find the amperage of your light by using the Power Law which states that amperage = wattage divided by voltage. Thus a 60 watt bulb on a 120 volt system would draw .5 or 1/2 an amp.
Current carrying capacity is different.
The maximum current output of a CT is 5 amps. Connected to a meter this will be full scale. What ever the ratio of the CT will dictate the scale face on the meter. A 500 amp CT's output will be 5 amps at 500 amps on the buss. 250 amps on the buss, the CT will output 2.5 amp or half scale on the meter face.
It's the standard Type 'G' 3-pin plug used in the UK for electrical equipment and appliances. It should always contain a cartridge fuse of the right size to match the current or "amperage" drawn by the equipment/appliance it is supplying with power. Standard fuses to fit the plug are available in 13 amp, 5 amp, 3 amp and 1 amp sizes. For more information see the Related Link and the answer to the Related Question shown below.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
1 amp
no you can't
A 5-amp fuse is designed to fail if more than 5 amps goes through it. A 6-amp fuse does likewise with more than 6 amps. Therefore, if you replace a 5-amp fuse with a 6-amp, you might be leaving components vulnerable to damage and wiring vulnerable to overheating, which could start a fire. If you replace a 6-amp with a 5-amp, the fuse will burn out if the circuit is drawing between 5 and 6 amps.
15 and 20 amps for receptacles and lights, and anywhere from 20 to 60 amps for dedicated loads such as water heaters and air conditioning. The fuse size MUST be matched to the load and wire size, you cannot just arbitrarily pick one!
No.
500 watts P=VI
well it might give you a clue, i would suggest a 5 ampere fuse for that 5 amp plug
This is a unclear question, and not easy to answer. In your fuse panal, their will be a range of fuses, from 5 amp, up to 30 amp. On your fuse panal cover, should be a digram of your fuse panal, and which amp fuse goes into which slot.
In the UK, you cannot put a 5 amp fuse in a 3 amp plug. The general rule of thumb is that you should use like for like.
Black
There is one 15 amp fuse, one 10 amp and one 5 amp fuse.