No, a watt is a watt, the voltage only changes the wire size. The power company bills you based on kilowatt hours. 1hp = 746 watts, no matter what the voltage.
No
No adapter is needed, 110 and 115 volt are interchangeable.
can you plug a 115 volt into a 110 volt
First and foremost you should look at the nameplate. If the nameplate is unreadable then you will do no harm plugging it into a 115 volt supply. If the motor looks like it is running at full speed then it is a 115 volt motor. If you plug it in and it looks like the shaft is turning at about half speed then it is a 230 volt motor. If the motor is running slow don't leave it plugged in for more that 15 seconds. Find a 230 volt supply and plug it in, it should run at the right speed. If you have a shaft tachometer use it on the end of the shaft to get an accurate rotation speed. The above prompted comparison with another motor, with the same RPM rating, allowing a simple feel of the shafts for a close speed match. The help is appreciated.
The wiring instructions for wiring a dual voltage motor are on the underside of the lid of the motors junction box. If it is not there look on the Internet for winding dual voltage motor connections.
The instructions will be on the nameplate or inside the cover where the terminations are made. The leads will be marked with numbers which must be hooked up like they are shown on the wiring diagram. A dual voltage motor has windings that are hooked up in series for 220 and in parallel for 110. Sometimes the diagram will state "high" or "low"
115 Volt and a 110 Volt can be treated as the same thing. The electrical voltage supplied from your electric company is not exact and can be 120 Volt + or - 10%.
The wiring should allow for 115 amps.
No adapter is needed, 110 and 115 volt are interchangeable.
Yes the 115 volts you read is just the maximum it will handle.
can you plug a 115 volt into a 110 volt
yes, most 115 volt devices will work with any voltage from 100 to 130 volts with no problem.
First and foremost you should look at the nameplate. If the nameplate is unreadable then you will do no harm plugging it into a 115 volt supply. If the motor looks like it is running at full speed then it is a 115 volt motor. If you plug it in and it looks like the shaft is turning at about half speed then it is a 230 volt motor. If the motor is running slow don't leave it plugged in for more that 15 seconds. Find a 230 volt supply and plug it in, it should run at the right speed. If you have a shaft tachometer use it on the end of the shaft to get an accurate rotation speed. The above prompted comparison with another motor, with the same RPM rating, allowing a simple feel of the shafts for a close speed match. The help is appreciated.
If it's bad, the pump motor will not start. It can be checked with a volt meter. You should have either 115 volts or 230 volts in and the same going to the motor.
The wiring instructions for wiring a dual voltage motor are on the underside of the lid of the motors junction box. If it is not there look on the Internet for winding dual voltage motor connections.
Yes
How to get fire on a 115 hp 1996 evinrude motor?
The instructions will be on the nameplate or inside the cover where the terminations are made. The leads will be marked with numbers which must be hooked up like they are shown on the wiring diagram. A dual voltage motor has windings that are hooked up in series for 220 and in parallel for 110. Sometimes the diagram will state "high" or "low"