Usually 30 amp
If you can observe the fusible link it should be open and there should be some charring on the glass. Use an Ohm meter to confirm fuse is blown. If it is zero ohms across the fuse it is not blown.
Use 8 gauge wire.
The typical rating of a hot wire relay contacts is 35 amp
250 kVA generators come in different voltage settings and this information is needed before a wire size can be given
It takes a 35 amp blade type automotive fuse
Usually 30 amp
15 and 20 amps for receptacles and lights, and anywhere from 20 to 60 amps for dedicated loads such as water heaters and air conditioning. The fuse size MUST be matched to the load and wire size, you cannot just arbitrarily pick one!
You will need to use #8 wire.
its above the brake pedal in the driver's door, theres a fuse box there, take off the cover look for a fuse around 35 or 25.... =============================================== # 26 is a 20 amp fuse for the lighter
On a 2003 Ford Expedition : Left Hand ( drivers side ) low beam ( # 25 / 10 amp ) Both sides high beam ( # 35 / 20 amp ) ( also , # 23 is a 10 amp fuse for the right hand low beam )
the standard size would be 65" L X 21" W X 35" H
Depends on the size of the wire going to the A/C. If the wire is AWG #10 you cannot install a 40 amp breaker. If the wire is AWG #8 you can.
What is the Solar panel wattage to use charging a 12 volt 45 amp battery.
If you can observe the fusible link it should be open and there should be some charring on the glass. Use an Ohm meter to confirm fuse is blown. If it is zero ohms across the fuse it is not blown.
35 in standard form is: 3.5 × 101
According to the owner's manual in the fuse panel in : Location # 2 is a 7.5 amp fuse for the blower motor relay , air bag diagnostic monitor location # 6 is a 7.5 amp fuse for the rear blower motor (without EATC) location # 35 is a 7.5 amp fuse for the rear blower motor (with EATC) And in your power distribution box in your engine compartment ( Ford recommends disconnecting your battery because PD BOX is live ) IN LOCATION # 2 IS A 40 AMP MAXI-FUSE FOR THE BLOWER MOTOR RELAY in location # 9 is the blower motor relay - Helpfull