250 kVA generators come in different voltage settings and this information is needed before a wire size can be given
35 KVA generator using for load 100 meter length which cable need to used
4kva
It depends totally on the voltage used.
A 10 mm cable is most commonly used for a 500 KVA transformer, 240 volt, 3 phrase. The size of the wire that is used in a transformer is based on the voltage.
5kw = 6.25 kva becoz kva = kw/ pf if we take pf is o.8
To answer this question the voltage of the genset is needed.
Yes, a 3 phase 95 millimeter for each phase 150 meters long cable is enough for a 285 KVA genset.
35 KVA generator using for load 100 meter length which cable need to used
20000ltr/hr
4kva
A 134 kVA cable typically refers to the size of cable required for a 134 kilovolt-ampere electrical load. The size of the cable needed will depend on factors such as the length of the cable run, the voltage drop allowed, and the type of insulation and conductor material required to safely carry the current. It is recommended to consult with a qualified electrical engineer or contractor to determine the specific cable size needed for your application.
max.load that can run on 62 kva dg is of 86 amperes.
16mm2
It depends totally on the voltage used.
speculation is that it consumes about .75 ltr of diesel in an hour
A 10 mm cable is most commonly used for a 500 KVA transformer, 240 volt, 3 phrase. The size of the wire that is used in a transformer is based on the voltage.
You can tap off approximately 833 200 amp panels from a 250 kVA transformer. This calculation is based on dividing the kVA rating of the transformer by the current rating of the panel.