Yes. You should use 8 AWG wire from breaker to AC unit.
A 20 amp breaker might actually be needed for the installation. It depends on the wattage and voltage of the window air conditioner.
a 2p 20 amp should work fine for a single 220 air conditioner,
A 12000 BTU air conditioner draws close to 15 amps. While it technically can run on a 15 amp breaker, you may want to use a smaller air conditioner to be on the safe side.
You need to find the rating label on the unit. It would not be unusual for this to happen. I expect you need a 20 amp circuit.
Yes, when you plug the air conditioner in to an ordinary house receptacle this is the configuration that exists. Just make sure that additional loads on that same circuit are not any more that 7.5 amps or the circuit breaker will trip. For air conditioners it is best to have a dedicated circuit right back to the distribution panel. This means that there can be only one appliance, the air conditioner, on that specific circuit.
A 20 amp breaker might actually be needed for the installation. It depends on the wattage and voltage of the window air conditioner.
a 2p 20 amp should work fine for a single 220 air conditioner,
A 12000 BTU air conditioner draws close to 15 amps. While it technically can run on a 15 amp breaker, you may want to use a smaller air conditioner to be on the safe side.
You need to find the rating label on the unit. It would not be unusual for this to happen. I expect you need a 20 amp circuit.
Yes, when you plug the air conditioner in to an ordinary house receptacle this is the configuration that exists. Just make sure that additional loads on that same circuit are not any more that 7.5 amps or the circuit breaker will trip. For air conditioners it is best to have a dedicated circuit right back to the distribution panel. This means that there can be only one appliance, the air conditioner, on that specific circuit.
A 5 ton air conditioner will need a two pole 40 amp circuit breaker to supply 240 volts over a cable of #8 copper wires. Included in this cable will be a #12 bare ground wire.
No. The breaker must protect the circuit components such as wiring, outlets and switches that are connected to the breaker. Therefore if you have a 30 amp circuit as dictated by its components you need to protect it with a 30 amp or less breaker.
Replace the 30 Amp Breaker with a 15 Amp breaker.
Need more information. It doesn't seem rationale that they are protecting the same circuit unless you are substituting one for the other for a test. A unit like an air conditioner may have multiple breakers and a higher value breaker may trip because the load it is connected to is drawing current in excess of the rating of breaker.
Not unless you change the wiring for that circuit. The breaker protects the wiring and if you install a 40 amp breaker on a 15 amp wire circuit you will have a fire in your home.
Residential power is usually 115 volts to 120 volts and will power a 15 amp air conditioner. If it is on a 15 amp breaker it may heat up the breaker and cause it to trip if it runs continuously in which case you would need to move it to a 20 amp circuit.A 20 amp circuit will handle 18 amps continuously without overheating the breaker and making it trip. A 15 amp circuit can handle 12 amps continuously without over heating the breaker.You cannot simply replace the 15 amp breaker with a 20 amp breaker because the 15 amp circuit uses smaller wire which might overheat.The term 110 is an old one. Most home power now is at least 115 volts.
The pool light is usually on a 15 amp circuit. The breaker feeding this circuit must have a GFCI rating.