0
Is a mossberg 500 and 600 the same barrel and will they fit a coast to coast master mag C660?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you activate webcam on Toshiba satellite C660 2D8?
This is how it is for my Toshiba satellite yours maybe the same or similar start/all programs / Toshiba / utilities / web camera application
How do you activate webcam on Toshiba satellite C660-2D8?
This is how it is for my Toshiba satellite yours maybe the same or similar start/all programs / Toshiba / utilities / web camera application
What laptop should I use to run Microsoft Flight Simulator X?
There isn't really a labelled laptop, but you want something that's either only for gaming or just has a large processor. Myself I run a toshiba Satellite c660/c660d, (not sure which it is.) with the i3 and windows 7. I find that even on high graphics it works fine, there's a small bit of lag, but you can tweak the graphics settings a bit to fix that. If your looking for something made for gaming, your looking for something with a reasonable graphics card and memory. As I say I can't really give you a "made for flight simulator laptop", but look around there's bound to be an affordable powerful laptop out there somewhere. If its a mac you have currently have, it will depend on what other things use up its memory, my laptop I use only for gaming, and it works fine. Hope this helps a bit,
How do I set up watermatic c660 chemical controller?
1st Make sure the probes are never left out of the water for long periods of time.2nd Verify that probes are attached and inside they should have about 4 layers of what looks like cotton disks stacked on top of each other. If it looks like a bunch ofcotton scattered all over the place then that means the probes are most likely no longer usable. (Bad probe = False Readings = bad chemical balance)3rd Set the pH & ORP to your prefered Set point. Usually anything between pH = 7.2 - 7.6 (No more no LESS), ORP = arround 650 ppm.4th attach your acid feeder to the pH and the Chlorine feeder to the ORP out put.5th for the next few days you'll need to check the chemical balance to verify that the unit is feeding properly. If the feeder is feeding too little or too much acid change the pH setpoint same goes for ORP.Good luck
