1st Make sure the probes are never left out of the water for long periods of time.
2nd Verify that probes are attached and inside they should have about 4 layers of what looks like cotton disks stacked on top of each other. If it looks like a bunch ofcotton scattered all over the place then that means the probes are most likely no longer usable. (Bad probe = False Readings = bad chemical balance)
3rd Set the pH & ORP to your prefered Set point. Usually anything between pH = 7.2 - 7.6 (No more no LESS), ORP = arround 650 ppm.
4th attach your acid feeder to the pH and the Chlorine feeder to the ORP out put.
5th for the next few days you'll need to check the chemical balance to verify that the unit is feeding properly. If the feeder is feeding too little or too much acid change the pH setpoint same goes for ORP.
Good luck
Of course you can. It is set up to use a controller.
you plug a dongle into your ps3
If your ps3 controller isn't working wirelessly, then you may have to reregister it. To do this, you have to plug it into the ps3 with the special cord. If it still doesn't work, even if it is left plugged in, then you may have something wrong with your controller and you may have to purchase a new controller. You should also check the charge on the PS3 wireless controller. if you unplug a PS3 that battery is not charged it will not work. When you turn off the PS3 if you have not set the PS3 to also turn off the controller automatically in controller setting the controller will remain on and the battery will drain. The PS3 does not charge controllers when it is off.
If you have a turbo button on your PS3 controller, then it is most likely a third party product, meaning it wasn't made by Sony. The turbo button will make a button set to it give rapid commands to the system, making your PS3 believe that you are pressing the button rapidly. To set a button to a turbo, first, press and hold the turbo button, then press the button you wish to map to it. You can normally have multiple buttons set to the turbo at a time
SIXASIX / The ps3 controller is Dualshock 3, it is wireless and consists of it's own battery which means you can carry all around the room and play, it costs $54.99 but with tax it would equal about $59.70 - 99 You can get the light up controller's in colors but mostly red and green. The ps3's Dualshock 3 controller's can be in Black,Red,Blue,Silver,and White, Ect. Good enough ?
Gas controller is defective /gas controller set for vacation / Gas controller set to low a temperature / Gas controller set on pilot
To set up a sixaxis controller on your PS3 for the first time, plug it in with the charge cable. Then press the PS button and wait until the controller connects. Your controller will now be set up to work with your PS3.
The d-pad is the set of directional buttons on the left side of the controller.
In order to set up active directory (Domain Controller), go to Start > Run > DCPROMO and then follow the on-screen instructions!
Yes it does and the controller must be set to turn off or it will discharge as long as it is left on
Of course you can. It is set up to use a controller.
no, you don't need one but but you can use one, you don't need a xbox 360 controller but the controller map is set to the 360
Logitech rumble pad is a great choice for a game controller.
Its kinda hard i can't setup for my controller so i use my keyboard and if you don't like doing that go get Project 64 and set up your controller there or keyboard or something
A Chemical Reaction
To have more speed in the proccesor.
To have more speed in the proccesor.