0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What size o ring for a futura mixer tap?
They have 6 different mixer taps, you have to state which one.
What are the advantages of mixer taps?
Mixer taps are extremely easy to use and one does not constantly have to try and get the perfect temperature and mixture of hot and cold water. Also one can make sure that hot water is not being overused.
How easy is it to switch from hot and cold taps to mixer taps?
Very easy once the supply lines to both the hot and cold water supply are shut and then work can proceed on changing out the "taps"
Where should a service valve be located in order to isolate the hot supply from the hot water storage vessel to the taps?
primary flow
Where can you buy kitchen mixer taps?
Kitchen mixer taps are available in a wide range of outlets both in the high street and online. These range from basic DIY shops such as B & Q to more specialist plumbers merchants and kitchen shops.
Can you play taps on trumpet with first valve down?
Yes, you can play taps on a trumpet using any valve combination, it will just be in a different key.
Where could one purchase Basin Mixer taps?
Hardware stores are your best bet when looking to get something for your home. In order to find a mixer tap for your shower it's best to look for a hardware store in your area. A few examples can be The Home Depot, Lowes, Ace Hardware, and any other stores you can think to find. Be sure to shop around for the best price!
Where would one find shower mixer taps for a newly installed bath?
Shower mixer taps can be found at stores like Lowes or The Home Depot. It would be found in the plumbing department in the store. You could also look for the product online if you have the dimensions written down, you could find one that you fit perfectly.
Where should a service valve be located to isolate the hot water supply from the hot water storage vessel to the taps is it the primary return or primary flow or cold feed or open vent?
The isolation valve should (must) be placed on the cold water side (and/or the return side), entering the water heater. Placing the isolation valve on the hot or outlet side of the water heater has the potential of creating a bomb.
How do water saving taps work?
They have a restrictor in the valve, so less water passes.
Are mixer taps better than separate cold-hot taps?
This is personal preference and depending on your pressure. mixers need a minimum of 400kpa to function properly, or they wont work, if your pressure is below this i suggest taps. maintenance wise, mixers will last longer, however are costly to replace cartridges, where as tap washers are cheap
Where should a drain taps internal service pipework be located?
immediately above the stop valve
