0
What else can I help you with?
Is street light system is closed loop or open loop?
An open loop traffic signal just cycles on a schedule and has no "knowledge" of traffic patterns or current traffic. A closed loop system would have sensors letting it know when traffic was present and a controller that would make decisions based on the traffic conditions.
What are the examples for open and closed loop control systems with their block diagrams?
traffic signal,blind person,
What is the difference between finite open loop gain and closed loop gain?
In a closed loop system the gain without the feed back loop being closed is called open loop gain!!! e.g if forward gain is "A" and feed back factor is "B" then open loop gain is "AB" and closed loop gain will be [A/(A+B)]
Is washing machine is open loop or closed control system and why?
closed loop system
Is voltage stablizer open loop or close loop?
Closed
What is the definition of closed loop control system?
A closed loop control system is a set of mechanical or electronic devices that automatically regulates a process variable to a desired state or set point without human interaction. Closed loop control systems contrast with open loop control systems, which require manual input.
Is automobile cruise control open or closed loop?
A cruise control is an example of a closed loop servo.
What is open loop or closed loop?
tumhari ma ki chut
Is a lawyer a open or closed loop?
It depends. Which is more corrupt? -- An open loop or a closed loop? Whichever one is more corrupt, selfish, and greedy, then that is the one that befits attorneys.
Why closed loop control system is much stable than open loop control system?
A Closed loop system basically will have a feedback which enables the rectification of the error in the main process,whereas it is not possible in an open loop system
Define open loop engine management as apposed to closed loop?
Yes i can anwer it.
What are the differences between an open loop and closed loop injection molding machine?
The difference between open loop and closed loop injection moulding is to do with the type of control system used. An open loop system changes the input signal relative to the pre-defined perameters of the system. A closed loop system uses a feedback signal ie it takes information from a point in the process usually the end and sends it back to the start where the system adjusts the input accordingly. To fully understand this I would suggest getting a good book on control theory. I use 'Modern Control Engineering' by Katsuhiko Ogata. Many people also use Richard Dorf but I find Ogata easier to follow. AuthorOgata, Katsuhiko.TitleModern control engineering / Katsuhiko Ogata.
