P 91 is a martensitic steel.
ASTM A105 - For ambient- and higher-temperature service in pressure systems. ASTM A350 - intended primarily for low-temperature service and requiring notch toughness testing.
Depends on temperature. For ASTM D323 the RVP of water is ~49.5 mmHg (torr) gauge or ~809 mmHg absolute (assuming standard pressure). FYI - ASTM D323 is measured at 100F.
A low cement refractory concrete is termed 'low-cement castable refractory'. It includes castable refractory based on alumina and/or alumino-silicates which contain hydraulic setting cement. The total lime (CaO) content on a calcined basis is between 1 and 2.5 percent. More information is available in ASTM C401.
This is one of the testing methods for gasoline and is also called Engler distillation. The whole method is based on the determination of boiling point by performing batch distillation. Boiling point is important for the safety and performance of solvents and fuels. It gives the composition, properties and behavior of fuel. Carrying out batch distillation also determines the volatility which majorly shows the tendency of hydrocarbons to produce explosive vapours. This also tells us the application in different industries depending upon the various temperature behavior of the fuel. Boiling point according to the standards limits distillation based on the product specification.
Basra is both a state capital and a state of Iraq. The largest field in the state is the Rumaila field, a huge field as documented in the second reference. Not only is there variation of properties from field to field, but also well to well within the same field. Therefore, the oil is divided into Basra light, medium and heavy. A Basra blend is about 31.5 degrees API. The sulfur content is 1.95%. I couldn't find more specifications on the internet. Variations will also occur over time, as the less desirable heavy crude is usually produced later in the life of the fields. See related links.
Maybe: Wrought Austenitic Stainless Steel Piping Fittings
The only difference between ASTM composite toe and ASTM steel toe footwear is the material they are made from. They both meet the same performance specification.
ASTM A213 T12 Standard Specification for Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, and Heat-Exchanger Tubes.
Please we need to know the equivalent material ASTM Steel for Q235B.
Please we need to know the equivalent material ASTM Steel for Q235B.
ASTM a-216 is cast material , it is formed by low carbon steel content. A 216 can be given pressure max 2000 psi/137 bar
ASTM A105 is a Carbon Steel material spec used in forged fittings, such as 2000# or higher socket weld or threaded fittings, forged flanges, etc.. ASTM A197 is a Malleable iron material spec used in 150# socket weld or threaded fittings.
Astm a-36
BSEN 10025-3GRS420N give me the material composition number
steel
The ASTM A-10 and, but it was discontinued and replaced by ASTM 283, the term mild steel is not recommendable for engineering use.
steel