analog signal
The PNP transistors conducts when there is no signal at base (0V or grounded), when base current is increased the conduction of PNP transistor decreases.
A bipolar transistor can be used in different configurations in linear electronic design. Most well known is the common emitter CE configuration with a base current as input signal resulting in a collector signal multiplied by the current gain factor. The second configuration is known as the emitter follower or common collector configuration. Here the input signal is in the form of a voltage between the base and the common connection. The output signal is found in the form of a voltage at the emitter with a relative low output impedance. The voltage swing at the input is almost as large at the output where the input impedance equals the product of the current gain factor and the emitter resistance. The third configuration is known as common base CB. Here the input current at the emitter almost equals the output current at the collector. The current gain is nearly equal to 1.
a current flow close to a magnetic source it influence the sources hall effect is a disturbed signal as a function of speed.
The symbol 'A' indicates that this device is made from germanium . as you may know germanium has less cut in voltage so this device is used for low power signal or for signal processing. also the leakage current or reverse saturation current of germanium is greater than silicon.
current to preesure converter means....current signal to pneumatic signal...
A current signal is converted into a pneumatic signal with a Current-to-Pneumatic Converter. The converter allows a safe and proportional output to ensure a seamless conversion.
DC current
The main Difference between Voltage and Current Feedback Amplifiers is in the sampled(Output) signals. In Voltage feedback the sampled signal is voltage (Vf=Beta*Vo) where Vo is the sampled signal and for current feedback it is current signal (Vf=Beta*Io).
to keep the signal awy from the dc limit ,, to ban the clipping of the signal
that is where the end stage does not consume current when there is no signal to amplify. Opposite of a class A where the current is constant with any signal level (except saturation...)
an analog signal
kittys a w____R and so are you :)
Electronic signal.
Yes. That is what microphones do.
It is a direct-current amplifier in which the dc input signal is filtered by a low-pass filter, then used to modulate a carrier so it can be amplified conventionally as an alternating-current signal; the amplified dc output is obtained by rectifying and filtering the rectified carrier signal.
It is a direct-current amplifier in which the dc input signal is filtered by a low-pass filter, then used to modulate a carrier so it can be amplified conventionally as an alternating-current signal; the amplified dc output is obtained by rectifying and filtering the rectified carrier signal.