Most antifreeze manufacturers include a guide in the instructions that you should follow based on the normal temperatures that the vehicle will be driven in. Some are also already pre-mixed so read the instructions carefully before using.
50/50 mix of water and coolant is recommended.50/50 mix of water and coolant is recommended.
you always should mix coolant with water if it is full coolant. most coolant today says 50/50 on the package and is pre mixed in which case no, but if it is straight 100% coolant, yes mix with water.
Antifreeze should be a 50/50 mix with water. If you bought pure coolant, mix with water. If you bought premix (already 50/50) pour in straight.
Water should be fine, but mix it with coolant when you can to prevent rust from developing in the radiator.
About 2 gallons of 50-50 mix of concentrated coolant and water.
It is usually best to add the correct mix of antifreeze and water (usually 50/50). In a situation where there is no antifreeze available, yes, add water, then check the coolant later to see if the mix is adequate, and adjust the mix if necessary.
In most cases a 50/50 mix of straight coolant and water is sufficient. Read the directions on the coolant container and adjust to your weather needs.
50 50 coolant is what i use- would suggest no more han a 60 40 mix.
If the reservoir is low, ad a 50/50 mix of coolant and water. Or, buy it premixed and ad as is.
Clean water, preferably drinkable water.
Usually 50 / 50 mix ( Ford states not to exceed 60 % antifreeze and preferably distilled water )
first if coolant and water mix was not prepared as needed to your state climate .coolant on your rad will continue to freeze ,...if it is frozen run hot water on rad assly also installing a block heater will help in heating you engine before starting on mourning's.knowing the state you are from ask local mechanic's what is the mix rate or percentage in which to mix coolant and water,...