Want this question answered?
DC Series motor should never run without load connected to it because starting torque for DC series motor is infinite and running it on no load will damage the motor due to overspeeding.
if you run the unloaded motor at max rpm the centrifugal forces will cause the motor to be totally destroyed so it is advisable to not to run it at max rpm it should be okay to run it till 50% of max rpm without loading it
Yes, just swap any two wires to reverse it
If a motor is running when the cap fails it will probably continue to run at much higher amp draw and most likely shut down on thermal overload. It can start with a bad cap, but in my experience it most likey wont.
It makes the motor run insufficiently.
probablly a bad ignition switch or blower motor not sure on that should run without power
no.
It won't run properly and you may as well change the motor.
The most conclusive test of a blower motor is to run a wire from the battery directly to the motor, being careful not to ground the wire out anywhere by accident. If the motor will not run when wired directly to the battery, it is probably bad.
DC Series motor should never run without load connected to it because starting torque for DC series motor is infinite and running it on no load will damage the motor due to overspeeding.
faulty thermostat, stuck fan relay, bad fan motor, no voltage to motor, bad circuit board, bad run capacitor...
Possible causes: Motor is bad (can you hear the motor run?) Belt the from the motor to pulley/drum is worn or broke Bad timer or control unit
No, unless the motor was wound for dual voltage operation, which it will state on the motor nameplate, a 110 volt motor run on 240 volts will be damaged.
What can happen when a blower motor resistor goes bad is that the motor will run and then suddenly stop running on a regular basis. Sometimes the blower fan will not turn on and cause the motor to overheat.
It is probably a bad motor, or a loose ground going to the motor. And there is the possibility of a bad switch, if it only occurs at one speed.
a motor can not run with out oil, the motor will seize up and can break parts
unplug motor run fused jumper from batt and touch to two wire plug on motor