If you ride for short trips, your glass will be foggy because the engine hasn't totally warmed up. Take it out for an hour and it should be ok
:if its that foggy then change your oil before you gotta change the motor:
there should be a sight glass on the right side of the motor
if you are referring to the sight glass when the tractor is running the fluid will not be seen in the glass because it will be in all the hydraulic lines and pumps
There's a sight glass on the side of the gerabox case. If you have enough oil in it, it will be visible in the sight glass. If you can't tell, then you either don't have enough or have too much. If you have too much, it will come out the breather tubes on the top of the case when you're running it.
Units that allow observation of fluids inside a vessel, tank or pipe is called sight glass. Using sight glass, plant managers can observe and note pressure changes, fluid reactions and so on inside a vessel, tank or pipe. Sight glass is also called viewing glass. Observing fluids and its changes play critical role in many processes. Sight glasses are usually corrosion, abrasion and pressure resistant. There are different kinds of sight glasses available in the market. Sight Glass is usually designed in metal frames made of glass disks and meets the requirements of sanitary fittings. Sight glasses are used in fluid handling systems, boiler systems, industrial burners, pulp and paper processors, oil and gas refineries, automobiles, combustion equipment etc. Noble Glassworks is a leading sight glass manufacturer in India whom you can get in touch for all kinds of sight glass supply.
there is a sight glass on the lower right side of the engine fill oil to top of sight glass is full
water
There is no dipstick on this motorcycle. There is an inspection window called "a sight window" on the bike's right side when sitting on it, a bit forward of the rear brake pedal. There are two lines on the sight glass. They form the upper and lower oil level indicators. The oil should be at the upper or between the two levels. It happens that the oil level cannot be seen through this small window but it can be cleaned by turning a small screw located in the middle of the sight glass. This turns a small wiper blade that cleans the glass from the inside.
There is a sight glass on the side of the engine. With the bike sitting level, the oil should be between the two marks on the engine case beside the sight glass.
no
Actually there is no dipstick, there is a sight glass on the left lower side of motor with 2 marks on the case . The upper mark is the full level. You can see the oil thru the round glass sight glass
you can see through glass without change on the other side
theres no dipstick on a yammaha yz, theres a clear glass sight when the bike is level the oil should be visible in the sight glass!! careful not to overfill above the glass, if you do let some out till you can visibly see the oil level!