yes it is just a couple of bolts and the pads slide out easy
It is pretty easy. The front pads have a special clip that has to be clipped on the caliper. The rest is just as easy as changing any car's front pads.
It can be easy to change the brake rotors. Lift the car, remove the tire, brake shoe and rotor, put on the new rotor, replace the brake shoe, tire and lower the car.
remove bumper, replace with new one.....easy huh ?
This is easy.. http://www.carstereohelp.com/stereoremovalNispthfndrDrPnlR.htm pictures and everything :)
Changing brake rotors is pretty easy. One lifts the car, removes the tired, brake shoe and then the brake rotor. Next replace the brake rotor, put the brake shoe and tire back on the car and lower it back to the ground.
Easy
remove the trunk lining or bend it back easy where the brake light is to access it and change it out.
Squeze the caliper piston in with a pry bar or c- clamp and reomve the 3/8 Allen bolts, asembly is easy also
if you are talking about the front then all you have to do is 1. jack the side u are going to work on up 2. remove the tire 3. remove the brake cablier 4. slide the rotor off 5. EASY
There is a skid plate under the front bumper. Remove the 2 bolts to the cover in the middle of the skid plate, and you will have easy access to the filter.
It is not as easy and it is probably necessary to get a manual on your car from AUTOBOOKSONLINE.COM.
Well first you have to ask yourself if it is disk or drum in the front. Now most vehicles in that year are disk in front and drum in the rear. If it is a disk brake setup it should be fairly easy. First you must remove wheels, then you must see how the caliper is bolted on. Then un bolt it. Make sure you see how the brake pads are set into the caliper before removing. Remove. Replace. Installation is opposite Removal.