0
What else can I help you with?
How many oxygen sensor for BMW 325i has?
Hi well i am a Ex-Bmw tech. and a tech HAHA but there are 4 Oxygen sensor... there are 2 Pre sensor and 2 After sensor.. easy to see but sort of a Pain to replace. If its a E46 not a E36
How to replace an oxygen sensor on a 1990 Acura Legend?
its in front of car in the exhaust manifold, u need a special socket to remove oxegyn sensor. fairly easy
How do you replace an oxygen sensor in a 1995 Nissan Quest?
It is very easy to find. It is at cat. inlet. you can see it from the top when you open the hood.
How do you replace the oxygen sensor on a 2003 Toyota Matrix?
Find very good instructions with photos at: http://matrixowners.com/topic/72977-diy-how-to-change-an-oxygen-sensor-in-a-matrix/ I used them and they are easy to follow. Replacement time 15 minutes.
How do you replace an oxygen sensor 1993 Nissan altima?
The O2 sensor is located in the exhaust manifold on the front of the engine. To change it you'll need a 7/8 box-end wrench. Just unplug the wire from the harness, unscrew the sensor and replace it. It's pretty easy.
Is O2 sensor on 96 cavalier easy to replace?
Yes
Where is the oxygen sensor located in a 2002 Tahoe and is it easy to change?
there are more than just one o2 sensors on a 02 tahoe. they are lacated in the exhaust pipe before and after the catalytic converter. and yes they are easy to replace.
How do you replace the upstream and downstream Oxygen Sensor on a 2006 Chevy Equinox?
From underneath car there about 2' apart on either side of converter. Upstream is much harder then the downstream which is easy
When a scan shows your oxygen sensor needs replaced does the upstream or down stream or both needs to be replaced on your 1996 Geo metro 1.3 4-cylinder?
If they are the same sensor... replace the easy one first and if the code returns, take the old one and replace the other one
Where is oxygen sensor located on 89 jeep Cherokee?
The Oxygen Sensor on a 1989 Cherokee 4.0L is on the exhaust pipe on the left side of the engine just below the exhaust manifold. You can see it from above but you must replace it from below. It is pretty easy to reach. I recently changed mine and it took only 10 minutes using an O2 sensor wrench.
How do you replace front cross member of 2003 Chevy Tracker?
I own 2003 Tracker 4x4 4 cyl. My crossmember is rusted out and the dealer will replaced- no cost to me. But I have question: if the crossmember is out - will be easy to replace the oil pan and starter ? any saving for me? Mark
How many oxygen sensors in 2004 Saturn ion?
For the 2.2 liter, there are two. One is a pre catalytic converter sensor, and the other is post catalytic converter. They are very easy to access and replace.
