yes because ANYTHING is possible
Rough side up
if you want to overtake a horse rider you do it on the outside !!!
The low side (smaller fitting).
A mascot is someone inspirational that is on the sideline or at court side in a event. He/she is basically cheering for it's hoe team.
low side of a/c is the larger diameter line it the smaller fitting(charge side) vs. high side is your smaller line larger fitting
A mascot is someone inspirational that is on the sideline or at court side in a event. He/she is basically cheering for it's hoe team.
if you are referring to the a/c lines just trace the biggest line from the back of your compressor to the fitting and that's your low side port.
If you are wondering where to add R134a on the low side, the fitting is located on the passenger side of the car, near the compressor and towards the headlight from the drive belt (fairly close, about a foot away, to the radiator). There should be a black cap (screw) just like a valve stem cover on a tire covering the valve. The high side connector is located in the engine compartment, passenger side, near the fender well back towards the alternator and very close to the drive belt. The high side fitting is much harder to find (see) than the low side- the low side is right out in the open. The fitting you have for adding R134a from the can will not fit on the high side. The high side fitting is larger than the low side fitting.
A threaded copper fitting on the copper side, male or female, and the galvanized is screwed into it.
The low side will be located on the front side of the a/c manifold..........
The low side has a bigger fitting then the hide side
LOCATE THE SERVICE FITTINGS Next, you need to locate the service fittings on the A/C system. There are two: a LOW side fitting and a HIGH side fitting. The LOW side fitting is usually located on the suction hose or line that goes from the accumulator to the compressor. The HIGH side fitting is located on the line that goes from the compressor to the condenser. R12 Low Side 7/16 in. threaded ß----------à R134 Low Side 13mm Quick-disconnect R12 High Side 3/8 in. threaded ß----------à R134A High Side 16mm Quick-disconnect On older R12 systems, the LOW and HIGH pressure service fittings are screw-type Schrader valves. On newer R134a systems, the LOW and HIGH side service fittings are quick-connect style fittings. The LOW pressure fitting is SMALLER than the HIGH pressure fitting.