Not really, although depends on your knowledge, tools and manufacture era of each engine. Fuel injected or carbureted. Actually can be done in 6 - 10 hours.
it's in back of the engine . by the distributor . 2 wire going in. not to hard to change .
hard strt and 10 min running engine and die
Very.
It is in the back of the engine, right behind the driver's side head, It is hard to see.
I`M HAVING A HARD TIME REMOVING SPARK PLUG WIRES ON MY 2002 CHEVY SILVERADO 2500 6.0. ANY TIPS?
maf sensor
It is screewed into the top of the engine block right behind the distributor. It is hard to see and to get to.
There are two, they go from the engine to the firewall and Yes they can be hard to reach
It may be hard or easy depending on the access to the belt and what car it is ?
Unplug it, Then take the bolt out that holds it in place. Then install the new one. No big deal. You can find it behind the driver's side head where the transmission bolts to the engine. It is hard to see.
No you do not but the dip stick is very hard to find
It is located at the engine side of the upper radiator hose.It is a little hard to see.The housing is located behind and below the A/C compressor.