It only requires removal of the large silver cover (two nuts) and then the six to eight bolts per side that hold the coil module / pack on to the cam covers.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
To replace the ignition coil on a 2001 Kia Sephia, first, disconnect the negative battery terminal to ensure safety. Remove the engine cover if necessary, then locate the ignition coil, which is typically mounted on top of the engine. Disconnect the electrical connector and unscrew the coil from its mounting, then replace it with the new coil and reassemble in reverse order. Finally, reconnect the battery terminal and check for proper operation.
How change my ignition switch nissan 2001 sentra.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
On a 2001 Volvo S40, ignition coil B is located on the engine's cylinder head, specifically for the second cylinder from the timing belt side. The ignition coils are arranged in a line, with each coil corresponding to a specific cylinder. To access it, you may need to remove the engine cover and possibly other components obstructing the ignition coil. Always refer to a repair manual for detailed guidance specific to your vehicle.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil
You can find ignition coil for a 2001 Blazer on http://www.made-in-china.com/products-search/hot-china-products/Ignition_Coil.html
On a 2001 Ford Expedition : Both the 4.6 and 5.4 have the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils
The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
UNDER THE COIL PACKS