answersLogoWhite

0


Best Answer

On 4 cylinder it takes about 20-30 minutes. For V-6 it might take couple hours.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it hard to replace the valve cover gaskets on a 1998 Toyota Camry?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Oil leaking onto exhaust manifold Toyota Camry?

The oil leak is coming from the valve cover gasket and leaking onto the exhaust manifold, the rubber valve cover gaskets get hard from the engine heat and start to leak, you will have to replace the rubber valve cover gaskets to stop the oil leak


1996 Toyota Camry valve cover gasket?

how do i remove the valve cover to change the gasket in a toyota camry 1996


How do you replace a side mirror on a 2004 Toyota Camry?

Take the inside cover off and there should be 3 bolts holding it on.


Map light replace bulb in 1996 Toyota Camry?

To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.


What is the torque specifications for a 1996 Toyota Camry 4-cylinder valve cover?

what is the torque specifications for a toyota camry 4-cylinder valve cover


How do you remove and install a 1998 Toyota Camry rear bumper cover?

Hi, I was looking for instructions as to "How to replace 1998 Toyota Camry rear bumper cover" and you got your question. If you have already replaced then please let me know otherwise I'm going to replace the part this weekened and I will let you know. Take care, Sam


How many miles does a Toyota Camry cover with a gallon of gas?

That would depend on many things. The year of your Toyota Camry, engine size, and how you drive.


How do you clean a cloudy Toyota Camry cloudy headlight cover?

Sell it!


When do you change the valve cover gasket on a 2003 Toyota Camry?

When it leaks.


How to replace the front speakers on a 1988 Toyota Camry?

A very short Phillips head screwdriver to remove the 2 screws in the cover and lift out. There is not much roomk.


How do you get a 97 Camry's dome light cover off?

There are no screws in the dome light cover of a 1997 Toyota Camry. You can pry the cover off with a flat bladed screw driver.


What is the cost to replace valve cover gaskets on 2001 Subaru legacy?

The cost to replace valve cover gaskets on a 2001 Subaru Legacy is about $600. If the work is done at home the cost is only $100 to $200.