Mercury Cougar

Is it necessary to depressurize the fuel line to change the fuel filter on a 1999 Mercury Cougar 2.5 V6?

353637

Top Answer
User Avatar
Wiki User
Answered
2015-07-16 18:10:54
2015-07-16 18:10:54

Either that or put a rag around the fitting you are loostening to keep from spraying fuel all over the place.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do you change a water pump on 1993 Mercury Cougar

How do i find the instructions for changing out the fan switch assembly in a 2001 Mercury Cougar?

You need an oil change.

It will take a skilled mechanic approximately 5 hours to change the fuel pump in your 1991 Mercury Cougar. It can take a novice mechanic much longer.

the transmission has to be spit apart in order to change the trans filter.

According to my Chilton's Auto Repair Manual : For the 3.8 liter V6 engine in a 1991 Mercury Cougar : With engine oil filter change : ( 5.0 US. quarts )

Replacing the tire on a 99 mercury cougar is fairly easy. Jack up the car, remove the rim bolts and the tire will come off. Put on new one and reassemble.

Remove the wiring harness from the bottom of your 1996 Mercury Cougar automatic antenna. Remove the retaining nuts at the bottom of the antenna. Reverse the process to install your new automatic antenna.

Remove radiator cap. Push Cougar out of the way. Push a better car under the radiator cap. Install radiator cap.

The Owner Guide for the 1999 Mercury Cougar shows ( 5.8 quarts with filter change ) for the 2.5 liter V6 engine

you have to raise the motor or drop the k member, or both

I'm assuming it is the same as the ( 1996 ) Mercury Cougar 4.6 liter V8 : With engine oil filter change : ( 5.0 U.S. quarts should put you almost to the full mark )

According to the 2000 Mercury Cougar Owner Guide : With engine oil filter change : The 2.5 liter V6 engine takes ( 5.5 liters of 5W-30 engine oil )

The 2.5 liter " Duratec " V6 engine used in a 1999 Mercury Cougar uses ( 2 ) timing CHAINS , both located at the front of the engine ( 1 chain to each cylinder head )

You have to pull the gauge assy out and the lights are mounted from the rear. Run1

Check out autozone.com's repair guides online, under suspension, they have a good guide for doing it.

Remove the tire and wheel from your 1999 Mercury Cougar. Remove the axle end. Remove the wheel bearing retaining nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.

According to the 2001 Mercury Cougar Owner Guide : For the 2.0 litre four cylinder engine : ( with engine oil filter change , 4.25 litres / 4.5 U.S. quarts of 5W-20 engine oil )

To change the serpentine belt on a 1988 Mercury Cougar, first take a picture of how the old belt is put on. Then, loosen the nut on the tension pulley and remove the old belt. Use the picture to route the serpentine belt in the same pattern as before. Tighten up the nut on the tension pulley.

some of the Mercury cougars had a recall on their fuel pump..symptoms are you have to keep your gas tank filled at least at half and over or when it gets below half bogging occurs..this is covered for up to 10 years..if your having this problem it can be fixed for free..just go to your ford dealership..i have a 2000 cougar and it had the fuel pump problem. how do you change the fuel pump in a 1999 cougar

1995 Mercury Cougar does not have front wheel brake shoes. It has disc brakes and therefore disc brake pads. Copy & paste this link into your browser. http://www.advanceautoparts.com/english/youcan/html/ccr/ccr20021101db.html

According to the 2002 Mercury Cougar Owner Guide : The 2.5 liter V6 engine takes : With engine oil filter change : ( 5.5 litres / 5.8 US. quarts of 5W-20 engine oil )

disconnect the negative battery cable for 60 seconds then re-connect should do it


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.