0
Is it possible for water to enter a pressure switch on a RUUD gas Furnace?
Wiki User
∙ 13y ago
If you mean a vacuum switch then yes. Its fairly common for condensate to accumulate in a vacuum switch.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you change font size default in tvs msp 250 star printer?
switch off the printer, then press font style button and switch on, you will enter into settings menu, when entered it will print the detail of the settings that how to operate.....
3 If you're central AC and heating system has two intake ducts in each room high and low which should be open in the winter when you are heating the house?
First, I will assume that the two "intake" ducts deliver air from the furnace or air conditioner depending on the season. These are usually referred to as "supply ducts." Since air warmer than the surrounding air rises, which would be true if it was coming from the working furnace in winter, the maximum transfer of heat from the air entering the room to the air in the room (by mixing) will take place while the air rises from a supply duct at the low point in the room. Hot air entering from the upper supply duct would stay at the ceiling of the room and only transfer heat to the other air by radiation. The room would be heated mainly by replacement as the cooler air below was drawn to the return duct (usually just one on the main floor in a large common room) which returns the air to the furnace. If the two "intake" ducts come from the furnace, then the other duct should be shut unless it can act as a return to the furnace for heating. Either way, the warmer air should enter as low as possible and the cooler air be drawn out from as low a position as possible. The logic of reversing this system in the summer (cold air entering in the upper ducts and exiting through the [doorway to the one] return duct should be obvious.
What is a vacuum breaker?
A vacuum breaker is a mechnical device used to avoid backflow or a negative pressure in a plumbing system. It typically consists of an air valve with a spring holding it closed. When the pressure within the system is positive, the valve remains closed. When the pressure is negative (less than atmospheric), the negative pressure overcomes the force of the spring holding the valve closed and the it opens, typically allowing normal atmospheric air to enter the system, thereby eliminating the negative pressure. Otherwise, the negative pressure might cause backflow of the plumbing system. ...
When should a switch statement be used?
switch is a loop which is used for checking various conditions and print corresponding matter.switch(a)//where a is that whose condition you have to check.#includemain(){char a;printf("enter a char.");scanf("%c",&a);switch(a){case 'a':printf("vowel");break;case 'e':printf("vowel");break;case 'i':printf("vowel");break;case 'o':printf("vowel");break;case 'u':printf("vowel");break;default:printf("consonent");}}
How do you write a c plus plus program that computes the sum mean and standard deviation of 50 numbers?
Assuming the image is an RGB image, sum the red, green and blue components of the pixels separately then divide each by the number of pixels. E.g., given two pixels RGB(a, b, c) and RGB(x, y, z) the mean is RGB ((a+x)/2, (b+y)/2, (c+z)/2).
What is the code regulation for the conduit that the electrical wire goes through when going to the switch on a furnace?
The furnace control switch can be located on the outside of the furnace room. This is in case of an emergency with the furnace, no one has to enter the furnace room to isolate the furnace from its power supply. Code rule from the CEC (Canadian Electrical Code) 26-806 - 6 - The disconnecting means shall be permitted to be a branch circuit breaker at the distribution panel board, provided that the panel board is located between the furnace and the point of entry to the area where the furnace is located. 7 - Where a separate switch is required, due to the unsuitable location of the branch circuit breaker, it shall (a) not be located on the furnace in a location that can be reached only by passing close to the furnace; and (b) be marked to indicate the equipment it controls.
Ac high pressure switch on a 97 Ford Taurus?
before you enter compressor it is "t"'d to pipe has 4 harness wires
Where is the Location of oil pressure switch on 1986 s 10 blazer?
The Oil Pressure Switch is located:Under hood, driver side, lower engine area, mounted in oil filter adaptorfrom : shortbox88@hotmail.comwww.autozone.com , has alot of answer's for the do-it-yourselfer's out there.click on repair guide on the left and enter info.
Is it possible humankind to enter the mantel?
no its not possible
Is it possible for humankind to enter the mantel?
no its not possible
What type of pressure causes to enter the venous side of the capillary?
Osmotic pressure...
How does hot water enter into houses?
It doesn't. It comes from the water heater which is usually close to the furnace. In the basement or utility room.
How do you do you switch your Pokémon in Pokémon Global Revolution?
press x and go on pokemon then press enter on the pokemon you want to switch and then press switch.
Is it possible to enter the Stonehenge?
Yes it is
What is the Difference between manual and electronic?
On entering a dark room, you would normally, manually, switch on the light. It is possible to use an electronic sensor and circuitry to automatically turn on the light when you enter the room, and to switch off the light once you have left the room for a specific amount of time.
Is it possible to enter an animal's mind?
Noit is impossible to enter an animal's brain
Is it possible to enter in Heathrow airport to see somebody?
You can enter Heathrow airport to meet arrivals and to drop-off departures. It is not possible to enter the 'air side' of the airport without a ticket.
