answersLogoWhite

0


Best Answer
The Oil Pressure Switch is located:Under hood, driver side, lower engine area, mounted in oil filter adaptor



from : shortbox88@hotmail.com

www.autozone.com , has alot of answer's for the do-it-yourselfer's out there.

click on repair guide on the left and enter info.
User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the Location of oil pressure switch on 1986 s 10 blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil pressure sender location?

1986 S10 Blazer 4X4 with 2.8L, The oil sender is located just to the right side of the oil filter and is a pain to get to...


Location of oil pressure switch on a 1986 Honda prelude 2.0 motor?

on top of oil filter plate it has one wire


Where is fuel pressure regulator on 1986 s-10 Chevy blazer 2.8 liter?

It is in the throttle body.


Where is the oil pressure switch on 1986 fiero 2.8L?

The oil pressure switch is located on the right side of the motor up towards the firewall.


Location of fuel switch for 1986 Buick roadmaster?

The Buick Roadmaster was not produced in 1986. They were made from 1991 to 1996.


1986 bronco switch ignition location?

On steering column behind lower cover.


Where is the location of a flasher for a 1986 Toyota pickup?

The 1986 Toyota pickup flasher relay switch is located beneath the dashboard on the drivers side of the passenger compartment. The flasher relay switch will be labeled as such.


Where do you find the cycling switch on a 1986 town car?

The low pressure cycling switch is on the low pressure line coming from the compressor. Most of the time, it will be located on the reciever/dryer. It will have two wires coming from it. The low pressure line is the bigger line of the two.


1986 Ford f-150 where is the location of high pressure fuel pump?

the high pressure pump is on the framerail just under the cab. drivers side.


Does a 1986 Chevy s10 blazer have ignition points?

No.


Can you swap the gas tank from a 1986 blazer to a 1987 blazer?

Yes you can. There the same. Just take the parts / sending unit out of the 1987 tank and install them in the 1986 tank.


Where is Inertia fuel switch location 1986 bronco ii?

under the dash near the transmission tunnel on the passenger side floor