0
What else can I help you with?
Is it possible to revert changes on this site?
Yes, it is possible to revert changes on this site, but there is a catch. You will have to become a supervisor to be able to access this feature
What is the possible system of Afghanistan?
Afghanistan is a possible democracy, and possibly can revert to Islamic theocracy.
What is possible unit for the product VI where V is the potential difference across a resistor and you is the current through the same resistor?
A possible/probable unit is Watts.
What is the function of UNDO command?
To undo the last step and revert document back to the position where it was before the step.
Is it possible to revert gunpowder back to its original form before it was ignited, and if so, what is the process to do so?
No, it is not possible to revert gunpowder back to its original form before it was ignited. Once gunpowder is ignited, it undergoes a chemical reaction that permanently changes its composition.
What is the use of position adjuster of multimeter?
How can you see a 1 ohm resistor on a 100k scale ?
AC only works when the blower is in the max position what is wrong?
Defective resistor pack.
What part of speech is revert?
Revert is a verb.
Is it possible to apply voltmeter across a variable resistor?
Of course. A good voltmeter can be applied across anything, since its impedance is high and its presence has no effect on the operation of the circuit. When it's connected across a variable resistor, the voltmeter most likely reveals a changing voltage as the resistor is varied.
Is it grammatically correct to say revert back to?
No, it is not grammatically correct to say, 'revert back to'. You would simply say 'revert', as in 'Can we revert to the previous subject?' Revert means to go back (to something), so saying 'revert back to' is saying the same thing twice, which is called tautology.
2004 silverado heater blower only works on position 5.?
Bad blower resistor?
Is the ignition coil resistor necessary?
Yes definitely it is necessary because when u crank the engine at that time ignition coil is in cold position so at that time complete 12 volts bypasses the ballast resistor but when u releases the key from cranking position so the key comes to the ignition position at that position 12 volt of battery goes through the resistor that may be approximately 9 volt because when engine starts the coil temperature increases and there is no need of 12 volts
