Mazda 626
Cleaning

Is it possible to clean the idle air control valve on a 1995 2 liter Mazda 626?

232425

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 03:00:55
2011-09-13 03:00:55

yes it is possible but you need a special Torx socket to remove the 2 safety screws holding it on. Be very carefull not to scrape any sealing surfaces on the piston and if using carb cleaner, keep it off the plactic and electrical parts.

I recommend, using either electrical cleaner, or brake cleaner as these dry and leave no residue. Be very careful taking it out of the throttle body, as to not lose the springs. Also, note the order it comes apart for reinstallation. spring, shaft and plunger, spring. Spray with cleaner, wipe clean. DO NOT spray into the throttle body. When reinstalling, be very careful not to lose the O ring on the throttle body. Tighten down. Also, if you lose the safety screws, don't fret. use the same size machine screws or bolts from any hardware store. Above all, take your time, and be careful: this part costs $400 and up.

001
🙏
0
🤨
0
😮
0
😂
0

Related Questions


According to Mazda, both the 2.0-liter and 2.3-liter engines have a maximum speed of 117.5 mph.

The millenia P - has 2.5 liter engine, The Millenia S has a 2.3 liter engine

The 2.2 liter 4 cylinder and the 3.0 liter V6.

Yes, there is a 1.6 Mazda

Your 1998 Mazda 3.1 liter engine does not have timing marks on the crankshaft. The timing marks are on the engine flywheel.

No. The 1994 and later Mazda B-series pickups are re-badged Ford Rangers. The 2.5 liter engine in them is an improved 2.3 liter engine that's been in Fords for many years. The Mazda B2200 uses a Mazda-designed engine that's fully different. Best bet is to go with a Mazda B2600i engine, or sell the pickup and buy something else. The i in B2600i stands for fuel injection, which increases power and gas mileage and reduces the amount of emission control equipment needed, simplifying the engine compartment.

The owner's manual of my early 2008 Mazda 3 s 2.3 liter says that it holds 4.5 U.S. Quarts of oil.

The amount of oil that goes into a Mazda 3 2.3 liter engine is 4.5 quarts. This would equal 4.3 liters.

The firing order for Mazda 2.0 engines is 1-3-4-2

What are the timing marks for 2.3 2007 mazda 6

what size is the motor 1.8 liter

The spark plug gap for a 1985 B2000 Mazda with a 2.0 liter engine is .8 mm. This is equal to .031 inches.

On a 1994 Mazda MX-6 : Both the 2.0 liter four cylinder engine and the 2.5 liter V6 engine have a timing BELT

Mazda named their truck models by engine size, so a B2300 is a 2.3 liter engine.

the engine can be either a: 1.6 liter 4 cylinder or 1.8 liter 4 cylinder

No , it is not an interference engine

cats play in their clean liter cause is nice and clean for them to use it that is why

The idle air control valve is also known as the idle speed valve. On a 1999 1.6 literÊMazda Protege, it is located at next to the throttle body.Ê

chain ( on the 2.3 liter 4 cylinder and the 3.0 liter V6 )

Timing CHAIN ( 2.3 liter 4 cylinder and 3.0 liter V6 engines )

The 1.6 liter Mazda firing order is 1-3-4-2 Distributor rotates counterclockwise.

yes, it has an oil filter.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.