0
Is it possible to install a rotor cap backwards on a Chevy 350 distributor hei?
Wiki User
∙ 16y ago
I DON'T KNOW!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Installing distributor Chevy S-10?
restabbing distributor and setting time I'm replacing 4 cylinder motor in a 87 Chevy s10 how do I install distributor and get the truck in time
How do you you install a distributor on a 1998 astro van?
how to install distrutor cap and rotors in a 1998 chevy astror van
What is the order to install spark plug wires to the distributor cap for a 1995 Chevy Lumina 3.1?
Get a shop manual. There is no distributor. These have coil packs.
Can you install a flywheel backwards on a 2001 Chevy blazer?
yes you can and you must have on right or starter will bind up
What parts do you need to install a Chevy HEI distributor into a Jeep 258 6 cylinder?
If my memory is correct you need a distributor from a Chevy inline 6, a distributor drive gear from an AMC 360 V8, and plug wires from a Ford inline 6
Where to install oil pressure switch on Chevy silverado 1500?
The oil pressure switch is located at the back of the engine next to the distributor. Looking at it from the front of truck it will be right of distributor. Normally it can be changed without removing the distributor.
Do you need to change the distributor on a new 350 crate engine to install it in a 57 Chevy?
i have a gm goodwrench 350 with a summit hei distributor in my 58 Chevy truckits about 1/2 inch from my firewallso... little room to spare but yes it worked
How do you change a distributor on a 98 Chevy Silverado?
how to repace the distributor on an 98 chevy silverado
Is it possible to install a steering column from a 1999 Chevy truck in an '82 Chevy truck?
not likely but good luck trying
What is the distributor setting for a 1996 Chevy Blazer 4.3 V6?
what is the distributor setting for a 1996 Chevy blazer
Will a Chevy HEI distributor replace a pontiac points distributor?
no
Where On a 1971 Chevy do you set the distributor to the 1 plug or 1 on the cap?
be it a 4,6,or8 cylinder....be sure you have the crank on TDC, top dead center, install the distributor so that the rotor is pointing to #1 cylinder on the cap
