answersLogoWhite

0


Best Answer

No, tighten it to prevent sparks and a possible fire.

No, tighten it to prevent sparks and a possible fire.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

12y ago

No, tighten it to prevent sparks and a possible fire.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it safe to drive a car with a loose battery cable?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The check engine light and battery light came on after you changed the starter?

i need to know if it is alright to drive this car like this Sounds like you left a wire loose, or blew a fuse. If the battery light is on, the alternator is not charging properly and it is not safe to drive.


What cable do you connect when installing a battery?

connect positive first then negative that is the safe way to do it


Is it safe to drive with the battery warning light on Renault clio?

Yes, it is safe but the battery will run down and the engine will stop. This will strand you on the road. The most likely problem is the alternator has failed and needs replacing.


Is it safe to drive the car when the car battery smell like rotten eggs?

If your car battery smells like "rotten eggs" then your battery is producing excessive hydrogen and is probably not safe. Please check you cars' charging system and make certain that the battery is not being overcharged. The battery can possibly explode.


Do you reconnect the ground or positive cables when installing a car battery?

Safe practice directs that when connecting battery cables to the battery, the positive cable should beattached first, and then the negative cable last. In disconnecting battery cables, safe practice directs cable order in the reverse, I.E., the negative cable is disconnected first, and and the positive cable last. The reason for this safety procedure is that IF the ground cable is attached first, then when using a metallic wrench to tighten the positive cable clamp, and IF the wrench in contact with the positive terminal clamp were to come in contact with any grounded metal of the vehicle, then a tremendous short circuit would occur. A massive short circuit results in massive arcing [fireball] which can severely burn a person, damage the battery [or cause it to explode], damage the vehicle electrical system, or worse, cause the vehicle to catch on fire. Always connect the negative cable last, and disconnect the negative cable first!


How to fix the shifter clip?

Is it safe to put back the cable into the clip after it was loose?Yes - it just may be coming loose again in the near future. Look at any bending or if the retainer clip is misshapen that can be straightened out.


How safe is it to drive a vehicle when the drive shaft is broken or faulty?

never drive any vehicle with a worn universal joint, you may cause serious injury to yourself or other drivers when the drive shaft lets loose on the road


Is it safe to drive a car if the control arm needs to be replaced?

It's never safe to drive a car with worn or damaged parts. If it breaks you could loose control of your vehicle and cost a life. The life may be your own. To be sure of the parts condition Uou should get a second opinion! Be safe most of all!


Is it safe to have your computer in the bathroom It wouldn't be touching any water besides Water Vapour It's for internet radio?

Yes. Don't plug in the battery charging cable.


Where can you buy a new battery tray for your 1980 cutlass supreme not the plastic kind but metal?

try ordering one from the dealer drive safe


How do you change a battery on an Oldsmobile Alero?

battery for Oldsmobile alero?dude ...The battery is located under the hood. just take out one bolt that hold the battery and take the two terminal cable out which is positive and negative.make sure loosen up the negative first just for safe?????????????////// I think the battery is hidden inside your driver side fender


If you have conected 4 6volt bateries in series which cable from the charger do you connect first?

same as any single 24v battery. Positive first then negative to frame just to be safe.