The output of an electric fencer is a high voltage pulse of DC voltage.
You would connect them in series to double the output voltage.
7.5v 500mA Dc charger
The brush-less motor controller has a smaller output current than one DC motor. The brushless also has less of a output voltage. The maximum output voltage is 50V, where a regular DC motor would have a maximum of atleast 60V.
change in load voltage or output voltage changes in load current
More convenient than what and for what? If you mean, more convenient than a giant squid as a way of powering your netbook, then yes, DC voltage is more convenient. AC also works for that if you have an AC adapter. But if you mean, more convenient than cinnamon as a flavoring for coffee, than no, I think cinnamon is both easier and tastier.
The output of an electric fencer is a high voltage pulse of DC voltage.
A DC to DC converter is a type of switching regulated powersupply whose input is a DC voltage, it then switches that rapidly to make AC, which is applied to the primary of a transformer, the transformer then either steps up or down the voltage as desired, the AC from the secondary is then rectified and filtered to provide the output DC voltage. Regulation circuitry measures the output DC voltage, continuously adjusting the switching circuits on the input to keep the output constant.Most switching regulated powersupplies are DC to DC converters with a simple unregulated rectifier and filter to convert the input AC to DC. Usually it is called a powersupply when it provides more than one output DC voltage or if its input is AC; whereas it is called a converter only if it provides just one output DC voltage and its input is DC. But most of the circuitry is the same in both cases.
By using something called a voltage divider.
megger are available in ac &dc
Output power can never be more than input power. With a transformer, it is possible to increase the output current (while decreasing the output voltage), or to decrease the output current (while increasing the output voltage).
The rf output voltage should be proportional to the signal voltage in AM. A change in the DC supply voltage should also cause a proportional change to the rf output voltage.
You would connect them in series to double the output voltage.
7.5v 500mA Dc charger
There is no transformer used in PC power supply. There is rectifier used to rectify or convert AC input voltage into DC output voltage.Transformer based rectifier produces some spikes at the output DC voltage, hencethey uses SMPS (Switch Mode Power Supply) to avoid spikes to the output DC voltage and get a smooth DC voltage.
If the DC source biases the diode off, then the output will be zero. If it biases the diode on, then the output will be DC, with the voltage being nearly the same as the input voltage.
dc