The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
There are 6 bolts that hold the trans. to the engine block.
The 4.3 liter V6 engine in a 1997 Chevy Blazer has a timing CHAIN
The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.
most likely an intake gasket
not much. probably doesn't tow the blazer that well
The 1989 Chevrolet Blazer 4.3 liter engine starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
how much play should a 4.3 Chevy engine timing chain have?
The spark plug gap for a 1994 full size Chevy Blazer with a 5.7 liter engine is .045 inches. This is equal to 1.1 mm.
in the engine block
A Chevrolet Blazer with a 4.3 liter vortec engine will take approximately 6 quarts of oil. The recommended type of oil is 5 W 30.
I know of only one in the waterpump.
No it does not.
The 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.
The GM 8.1 Litre engine is a 496 cubic inch big block motor.
The firing order for the 2001 Chevrolet Blazer is 1, 6, 5, 4, 3, 2. This is for the 4.3 Liter engine.
My 93 is on top in engine compartment left side. maybe yours is too.
Yes it will fit right in there and hook right up.
there should be a numbered stamped on the rear of the engine
Two, one on top and other on bottom
The 2004 Chevrolet blazer 4.3 liter engine cooling system has a capacity of 4.7 gallons. The cooling system should contain a minimum of 50 percent antifreeze.