Want this question answered?
Yes
The 67 has a rifled bore, the 67 smoothbore does not.
If the face of your tongue and groove is smooth then you don't need drywall. I have one whole room covered in T&G cedar and it looks great.
It is a trigger finger and it can be surgically released
Put an 18mm wrench on the lower tensioner belt and rotate CCW to loosen the tension. Remove the belt from around the alternator pulley, and slowly release the tensioner. Unwrap the belt from all the pulleys and install the new belt following the belt diagram located near the radiator support. ALWAYS make sure the grooved side of the belt is contacting the grooved pulleys, and the smooth side of the belt is contacting the smooth pulleys (Idler pulleys). Groove to Groove -- Smooth to Smooth
Smooth masonry tools. Groove tool. Drilling tools. The cutting tool. Screw cutting tools.
Rough, and pretty scaly.In some circumstances, if you move your finger in the right direction, smooth.Mostly smooth and scaly.
As long as the slug barrel is smooth bored(does not have rifling) then it can be used with bird shot.
Yes as long as you keep to the slugs designed for smooth bore shotguns,The Breneke is a ideal slug for your application.
Is the diagram on radiator support gone? Try an auto parts store they may have one a dealer will have one. Or do like I do. The back side (smooth side) of the belt will always go on a smooth pulley & ribbed will go on groved pulleys. Mark on a PC of paper the position on each pulley & which are groove-smooth. Takes a few min to figure out but it will work,
We have fingerprints because it provides a grip. If your finger tips were smooth it would be harder to grip things. The exact pattern is unique to each individual, although there are standard configurations.
that means that the break rotors have worn a groove an when you press on your break the pad is not hitting a flat surfice wich causes the peddle to shake an the reason it takes longer to pull up is cause the pad is not clamping the full surfice of the rotor due to it worn run your finger along the rotor it should be smooth if you fill little lumps means its shot an you need to get it fixed asap