The battery is the storage device for electricity in the vehicle. However the alternator is what creates electricity to keep the battery fully charged and to run all the electronics in the vehicle.
In an uninterrupted power supply there has to be a source of power when the electrical utility is not there. The only supply that is available is a battery that is in or connected to the UPS.
Starting with the Daniell cell in 1836, batteries were adopted by industry for use in stationary devices, particularly in telegraph networks where they were the only practical source of electricity.
If your battery is dead and you connect the power supply with your battery installed, the battery will automatically start charging. If you wish to run your MacBook off your power supply only, simply remove your battery from your MacBook and connect the power supply. You will then be running solely on the power supply. If you battery becomes fully charged while your power supply is connected, you MacBook will switch to the power connector as it's power source - preserving the battery.
The only difference between a battery drill and a regular drill is the type of power source. A battery drill is one that does not require a power cord, but can only last a finite amount of time.
In a standard gasoline engine, power is initially only needed from the battery to kick the spark plugs, after that the alternator takes over- keeping the battery level up and powering your electrical systems.
Engine Failure to Run if Battery is "Dead"Yes, a dead battery can not provide adequate electrical power to the ignition system and thus the engine cannot continue to run. Depending on the vehicle and electrical system, this can happen, even if the battery is not dead, but only to "low."
The main disadvantage is that it is only works fully in direct sunlight, so you need another source of power, like battery power or a connection to the public power supply, when the sun goes in.
An analog meter will respond to linearly as current is present . digital meters cannot do that not until the conversion is complete. in essence an analog meter is human friendly as compared to a digital meter. both have their places in applications.
Most gear switches contain fuse which are rate by the amps of the switch. As the name implys (SWITCH), it's use to either power or isolate a particular area with only one source of electrical power. While changeovers are directly connected by two different source of electrical power with the aim of supplying electrical power to an area by either of the power supplied by the two source of electrical power, e.g generator and general power from the transformer..
Yes if the power source is dry cell or small batteries. Electrical waves can be transmitted in any conductor. Video cable has lower resistance than a regular electric cable and it can only tolerate a minimal source of electrical waves.
No, they only transform light energy to electrical energy. If they are connected to a battery the battery will be able to store the electrical energy.
No, if you have your power plugged into your laptop all the time. Your battery will decrease its performance until your battery will last only a couple of minutes until flat.