0
What else can I help you with?
Is driver's side front spindle nut on Ford Festiva left handed thread?
No it is not reverse thread. The passenger side rear spindle is the reverse thread on 88-93 festivas.
How do you remove a magneto on a 96 blaster ATV?
With the tool, while they call this a flywheel puller it is a reverse thread nut, with a normal thread bolt in the center. After removing the nut holding on the mag, reverse thread the tool , then tighten the bolt in the center, off comes the mag.
How do you 'unstake' the wheel hub nut on a '89 Honda CRX?
Impact gun in reverse :)
How do you remove the Yoke nut on a 1999 Cherokee rear Differential?
I'm not positive, but you might take a look at the threads protruding from the nut to see if it is reverse threaded. I know a lot of pinion gears have a reverse thread on them. This would mean you would turn your wrench clockwise to loosen the nut. If you can't see the thread, check with your parts supplier to see if it is a reverse thread.
Is the cooling fan nut reverse thread for 1996 ram 1500 2wd 5.9?
No it is normal clockwise thread. It is normally very tight.
Is the nut that holds the front primary sprocket on right or left handed thread?
The front compression nut is right handed, however the nut hold the clutch hub is left handed.
On a 1999 Plymouth Voyager Is the nut on the wheel hub assembly reverse threaded?
No. Counter clockwise to loosen.
Is the front axle hub nut lefthand or righthand on a 2001 dodge ram 1500 4 wheel drive?
The axle nut is right hand thread. Turn it counterclockwise to loosen.
What size is the rear hub nut on a peugeot 406?
If you're after the thread size, it's M30x1.5 If it's the size of the nut across the flats it's 35mm or 1 3/8"
What is the torque spec on wheel bearing lock nut Dana 80 rear?
Start the hub nut making sure that the tab aligns correctly in the keyway prior to thread engagement. NOTE: The following hub nut tightening sequence will prevent side-to-side end play of the hub and brake disc assembly. NOTE: Apply inward pressure to the socket to separate the ratcheting components of the hub nut. To adjust the bearings, tighten the nut to specification. (70 lb/ft) Back off the nut 90 degrees. Tighten the nut to specification. (18 lb/ft)
What size socket do you need for a 1990 Toyota 4x4 hub nut you have everything apart down to that and can't get it off don't have the right tools?
not sure what size nut it is on hub,but it will be a metric size. also depending on what side of vehicle you are working, it may be left hand thread
Is Ford Laser wheel hub nut left hand thread?
The wheel hub nut on a Ford Laser is typically a right-hand thread, meaning it tightens clockwise and loosens counterclockwise. However, it's always a good idea to consult the vehicle's service manual or a reliable automotive resource to confirm this, as variations can occur based on the model year or specific configuration.
