0
What type of car? Explain contention better.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When you change brakes and still feel like not have no brakes and the brakes light is on still?
probably have a bad master cylinder.
Why is the brake pedal on your 99 silverado hard and your brakes are stuck?
Possibly a bad master cylinder.
Why does brake pedal go to floor on 1991 buick park avenue?
First, make sure the master cylinder is filled with brake fluid. If it is low, there may be a leak somewhere in the brake lines or a brake cylinder. If the master cylinder is bad, you can normally pump the brakes up, but the pedal will slowly sink to the floor again. The master cylinder needs to be replaced or repaired.
My brakes are not holding on my 93 buick lesabre?
Parking brake? Service brakes? Pedal dropping? Bad Master cylinder? ABS Module?
Why does a 2002 lesabre have spongy brakes?
There is probably air in your brake lines. Or you might have a bad master cylinder.
Can a bad hydro brake booster pump cause your brakes to seize up?
In most hydro brake booster systems the pump also runs the power steering system so if the power steering works the pump is okay. It sounds like you have a master cylinder problem.
I had no brakes when i pressed them they were soft and i barely go stopped 98 Chevy blazer?
Check your fluid level first. If it is low then your problem is a leak in the system. If the fluid level is OK then you probably have a bad master cylinder. To check the master cylinder pump on the brake pedal and hold the pedal down. Usually the pedal will slowly go to the floor. This means the master cylinder is not holding pressure. You should not take any chances with brakes!! Get them repaired at a qualified repair facility.
Why does the brake pedal still go to the floor even after bleeding the brakes on a 99 Mercury Villager If I pump them they will work but after sittin for a small length of time it feels spongy again?
leaking brake line or master cylinder..? It sounds like a bad master cylinder. Years ago these could be re-built, but with the newer ones, they must be replaced. By pumping the brakes, you build up pressure which prevents the piston in they master cylinder from leaking, cut after sitting, the seals leak again. A good mechanic will be able to tell if it is the master cylinder or not.
Why did you loose all brakes on tj jeep?
Fluid leak - check wheels for sign of leakage Bad master cylinder
What causes front disc brake to lock up?
Bad fluid in master cylinder,flush system,bleed brakes
On a 1994 ford tauras why do you get brake fluid to the front brakes but not to the back disc brakes?
You may have a bad master cylinder, or proportioning valve,Does the vehicle have Antilock Brakes (ABS) ? Please let me know.Ben
What is the cause of front brakes sticking on a dodge ram van?
This could be caused from the closing off of the flex line or a bad caliper or a bad master cylinder
