For an NPR the rpm sensor is located left rear of engine by the frame rail. Its actually the engine speed per service manual but when you need to replace the sensor the parts department calls it the rpm sensor. Good luck.
P0720 - Low Output SPD Sensor RPM Above 15 MPHThe relationship between the Output Shaft Speed Sensor and vehicle speed is not within acceptable limits. P0720 - Low Output SPD Sensor RPM Above 15 MPHOutput shaft speed is less than 60 rpm with vehicle speed above 15 mph (4-speed auto. trans. only).
Check your vehicle speed sensor. It controls your RPM's and your Speedometer. Hope this helps.
is the crankshaft position sensor the same and the engine speed sensor
change the TPS Throttle Position Sensor
The idle speed is computer controlled and is not adjustable. If the speed is incorrect, there is a malfunction with the idle speed motor, a sensor, or wiring.
Trouble code P0320 means: Crankshaft position (CKP) sensor/engine speed (RPM) sensor - circuit malfunction
The typical functions of a camshaft sensor are to monitor the speed of a crankshaft and what position it is in. It is used in an internal combustion engine and determines the RPM.
No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.No, the range sensor reads what gear or "range" you have shifted into.A speed sensor reads the speed of an item.
The VSS (vehicle speed sensor) may be at fault.
Clockwise at same rpm
It is probaly the mass air flow sensor.