Want this question answered?
There are code rule that allow the use of back feeding specific breakers. Before doing any such action check with the local electrical inspector. If your thoughts are along the line of feeding a generator into the electrical panel during a power failure, don't do it. There is electrical apparatus in the market place now that allows such action, use it. Remember that you can be help liable for any damage to utility company personnel or equipment.
depends what you mean, insurance will pay for a fire from an faulty electrical system, the insurance company will not pay for the faulty product itself only the resulting damage.
Storm related electrical outages may occur for a variety of reasons, most of which are caused by lightning strikes, fallen trees, or weather related damage to the components of the electrical system. If a major storm produces severe flooding, the local electrical power may be turned off to prevent accidental electrocution and to prevent damage to the main electrical grid infrastructure.
To prevent overheating/damage/fire of the electrical components in a circuit.
MCBs protects electrical circuits against the damage caused due to overload or short circuits
Investigate the extent of utility and facility damages
There are code rule that allow the use of back feeding specific breakers. Before doing any such action check with the local electrical inspector. If your thoughts are along the line of feeding a generator into the electrical panel during a power failure, don't do it. There is electrical apparatus in the market place now that allows such action, use it. Remember that you can be help liable for any damage to utility company personnel or equipment.
No, Your Gas Main is owned by the utility company, Just give them a call and they will come repair or replace it for you.
depends what you mean, insurance will pay for a fire from an faulty electrical system, the insurance company will not pay for the faulty product itself only the resulting damage.
Better to call your utility company to mark where the wires are before you dig. You could be liable for any damage and could hurt yourself.
SCHOOL IS ALWAYS THE SOLUTION BUT Electrical safety training starts with yours company's commitment to your well being. Our Electrical safety training course is designed to train your electrical staff on the proper care, maintenance, inspection and utilization of the electrical systems in industrial, commercial and institutional locations. It is also designed to ensure that arc flash program delegates are instructed to work within the guidelines of current Federal (CSA), provincial, Electrical Utility Safety Association (EUSA) and OSHA (Canada) safety regulations. Our arc flash protection program will help employees and companies reduce the risk of personal injury and equipment damage due to operator error.
Damage Control - company - was created in 2004.
Which is it, a power pole or a telephone pole? Contact the company that installed it and notify them that you believe that it is misplaced. <<>> Most utility company's lease their poles to the telephone companies so that two sets of poles don't have to be run parallel to each other. This being the case the telephone lines go where the utility lines go. If on the other hand it is a private telephone pole on private property that the utility company set for you, then the onus is on you to stake the exact placement where you want the pole to go and have someone on site when the digging starts to make sure that the pole is situated where you want it.
Yes.
Wasp can cause damage to electrical wiring. This occurs when wasps invade an electrical component such as air conditioning unit outside and build their nest inside of the unit. The most common occurrence is the nest causing an electrical short.
An electrical overload can cause electrical fires and damage your expensive electronics if not protected.
A ground leakage can damage electrical appliances. When there is a current leakage, it causes the appliance to draw more current through thecircuit, hence produces excess heat. This can damage the appliances.