Probably not due to computer not being compatible
all u need to do is pull the v6 and the wiring harness out of the car and install v8 with new harness.. v8 will fit right in the v6 frame
get the wiring harness from the explorer or donor vehicle that you get the 4.0 from, you need the harness from the 4.0!!!
Very carefully.
yes.you will need to change engine related wire harness and ecm
the sending unit is located near the bottom of the block on the left ( driver side) it is on the same harness as the oil level switch
no, need the harness too. Trans should work though.
yes you do and you have to swap out whole the wiring harness also
It is possible, it just requires a new pcm and wiring harness.
No 8 cylinders its 6 cylinders (v6)
yes just make sure you get CPU sensors and harness good luck
No, it was a v6.