Install the motherboard first. The drives will have wiring harness to connect to the motherboard.
You can if you get the 4L80E computer and wiring harness and install it in the vehicle that you are taking the 4L60E out of.
change the motor mounts and get the computer and wiring harness out of the donor car that the small block came out of.
Just get a wiring harness form e-trailer for about $30 it is easy to install has instructions with it. Wayne
what is color scheme?
You will need to remove the 1998 Chevy Camaro brake light wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light.
You will need to remove the retaining ring from the top of your 1997 Chevy Camaro ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
check wiring from battery to wiring harness to fuse (check fuse also) to harness to brake light. Check ground, too
Yeah but you have to modify you wiring harness and change motor mounts
it is possible, but you would also have to install the wiring harness, computer, and gauges from the vehicle which you are taking the v-tec from
The 2001 Chevrolet Camaro ignition switch is held in place with a retaining ring. Remove the retaining the ring and slide the ignition switch out. Remove the wiring harness. Reverse the process to install the new ignition switch.
Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
You can buy a speaker harness. An adapter that connect the positive and negative from the speaker into the stock harness.
Have you looked under the vehicle? I'd be surprised if the wiring harness wasn't already there and taped up under the vehicle. Barring that, most business that sell and install trailer hitches will also install trailer wiring harnesses. If you're a DIY, go to the local auto parts store and ask. They probably have the wiring harness you need all setup to plug into the manufacturer's wiring harness.
It is possible that you connected the power wire for the harness to the computer power. It was like that in my truck when someone did an at home addition of a wiring harness for the new head and changer. Check your wiring.
You can reset the 1997 Ford F1 50 pickup truck computer by removing the wiring harness from the computer. Keep the wiring harness disconnected for 30 seconds and then plug it back in.
buy a module and install it inline in your wiring harness
More than likely it won't work since the computer determines shifting depending on sensor values.
Remove the wiring harness from the back of your 1980 Chevy Camaro heater blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
It will fit right in there if you know what you are doing. But you will have to add a computer, fuel pump and some wiring harness to make that engine run.
well is it a radio wire harness because if so yes
you need the engine, wiring harness, and transmission. All three to make the swap.
I doubt it very much as they change electronics about every year.
YES, if you know what you are doing. You will need the complete engine and transmission wiring harness and computer plus the fuel pump for the 5.3L engine. The wiring harness and computer on the 97 will NOT work.