answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2014-10-07 00:56:54
2014-10-07 00:56:54

Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You will have to replace it. The bearings are worn out in the blower motor.


First, take a socket wrench to remove the cover of the blower motor of a 1993 Chevy truck. Then pull the motor blower out and install a new one in its place. Lastly, screw the bolts of the blower motor cover back in.


i cannot get the wheel off the blower motor


The first thing I'd look at is the switch and then the connections to the blower motor. Try bypassing the switch and see if the blower motor starts. Also, don't forget the fuse controlling the blower motor. Replace it with a fuse of similar size and see if that corrects the problem. If all else fails, just replace the blower motor unit with another. Go to the wreckers and you can get it for less than half price.


The blower motor fuse protects the blower motor electrical circuit. The blower motor relay operates only the high speed function of the blower motor. The blower motor speed resistor operates the lower speed functions of the blower motor.


Pictures and description http://www.cardomain.com/ride/299921/2


Not sure about the relay, but there is a blower resistor assembly located on the heater case to the right of the blower motor.


Remove the glovebox and brace. The blower motor is mounted there with 3 screws


Yes, you can use a windshield from a 1993 and up Camaro for your 2001 Camaro.


some vehicle, the blower motor is on the fire wall under the hood of the vehicle, but I believe on that make and model vehicle have the blower motor under the dash and half the dash has to be taken out of the vehicle to change it. good luck. Happy New Year.


Remove the wiring harness from the back of the blower motor in your 1993 GMC 1500. Remove the blower motor retaining bolts. If the new blower motor does not have the fan attached to and you will need to remove the fan from the old blower motor. Reverse the process to install the new blower motor.


The blower motor fuse is in the passenger compartment fuse panel underneath the dash on the driver's side. The blower motor fuse is a 30 amp fuse marked BLOWER.


If the blower motor quits, replace the motor. If it freezes over have the a/c checked. I want to know what genus came up with the answer above me you guys serious


como remplasar blower ac heater paseo 1993 toyota


To replace the blower motor on your 93 Bravada: Passenger side of the engine compartment, near the back of the compartment, there is a drum shaped component, usually black plastic. The blower motor slides into the center of this "drum" from the front of the compartment side, and is held in place by 6 bolts/screws. There is a short hose that connects to the blower motor and 2 wires. Disconnect the hose and the two wires, remove the 6 retaining bolts, and slide the blower out towards the front of the vehicle. You may need to remove the Engine Coolant overflow tank to remove the blower motor.


My heater / ac blower is not working, please advise.


AnswerShould be accessible at passenger side firewall under hoodIt's right behind the battery.


It is located on the blower housing to the right of the blower motor. There is a plug with several wires there. Remove the plug anf then 2 screws. Wala!



Should be under the hood, on the firewall, passenger side, not far from the blower motor.


The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.


The blower motor is located under the windshiel washer reservoir on the pasenger side of the vehicle next to the firewall.


The blower motor resistor is located under the hood, in the right hand cowl, behind the windshield washer bottle.............


go to, www.installdr.com , there you will find your answer


The A/C systems blower motor on a 1993 Acura Integra is located behind the glove box on the passenger side of the vehicle. Replacement requires removal of the glovebox, lower passenger dash, and covers. The blower motor is located next to the evaporator, and held by several mounting screws. Just unmount and unplug the blower motor to install the replacement unit.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.