Car Computers and Sensors
Ford Taurus

Is there a TPS sensor on a 2004 Ford Taurus SES?


Top Answer
User Avatar
Wiki User
2011-03-29 12:23:20
2011-03-29 12:23:20

yes there is 2004 Ford Taurus Throttle Position Sensor -


Related Questions

where is bank 2 sensor 1 in a 2001 ford taurus ses 6 cyl

built into mass air flow sensor

On a Ford Taurus V6 : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

SES = SE Sport. This is the Sport model of the Standard Edition Taurus.

You cannot "fix" it. But you can replace it in about an hour.

You cannot "fix" it. But you can replace it in about an hour.

If the engines are the same, and the exaust parts look the same, then it should work.

They have exhausts for The Taurus from 92-99 and '10 Use chat online to ask about installation.

How do you replace spark plugs on a 2004 Sable - Taurus?

According to the 2004 Ford Taurus Owner Guide : The 3.0 liter DOHC " Duratec " V6 engine takes ( 6.0 U.S. quarts with engine oil filter change ) * I'm assuming that the " Duratec " is the engine in the SES , if not , the 3.0 liter " Vulcan " V6 engine takes 4.5 U.S. quarts with engine oil filter change *

by looking at the engine. if it says duratec it has 24 if not duratec it has 12

It 's your dang old cam shaft syncronizer.

200 horsepower for the 3.0 L - DOHC - V6 ( Duratec ) engine

how do you find thepower relay valve circuit for the abs brakes

hehe... maybe, but it will look like a mickey mouse piece of crap.

on top of the motor its black and hooked to the throttlebody

you can for a limited amount of time. without the belt your battery will die, and cause your car to die

On a 2001 Ford Taurus : In the Power Distribution Box ( which is " live " ) located in the front of the engine compartment , near the battery ( mini fuse # 18 is a 20 amp fuse for the cigar lighter )

Add to radiator - but be careful some of these products will seal the heater core

8.0 to 8.2 seconds with 3.0 24 valve DOHC. About a second faster than the Vulcan 3.0 engine.

On the passenger side of the trunk behind the trunk liner ( there is an access hole in the liner )

Worn out Key, or module is shot. Try key first, and then scan at a dealership. Hopefully key. Cheaper... by hundreds of $$$$.

Remove the brake caliper, then the caliper frame mounting. ( just two bolts on the inside of knuckle) Now the rotor is free to come off.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.