Yes - there are many different formulae but the relationship of hardness to tensile or yield strength is at best very approximate. There is a general increase in hardness with increasing strength for most metals - where hardness has been measured by an indentation method such as Brinell.
The strength of metals is measured by the load (force) per unit area required to permanently deform the metal (this is the yield stress) or to break it (this is the breaking stress or fracture stress). The actual values of these quantities depend on the composition of the metal and on its mechanical and thermal treatment, and can vary by a factor of ten or more for common engineering alloys.
No. KSI is a unit of stress (1000 lb/sq inch). Grams are a unit of mass. Apples and Oranges.
By thick control.
we can weight one sheet and calculate the unit weight we can weight one sheet and calculate the unit weight
i dont know this nswer
ON the cad offset the bend radius from the internal radius of the sheet metal part by 40% of the total sheet thickness,and measure the chord length of the radius. that will be the developed length.
The strength, durability, and longevity of steel caskets depends first of all on the quality and thickness of the metal sheets used. The United States Standard Gauge for the thickness of metal sheets is based on the number of sheets required to total one inch. The gauge number (ga) informs about the thickness of the steel sheets in such a way that the lower the gauge number, the thicker the steel.
By thick control.
Be more specific. Are you refering to gauge thickness ie: 4 Ga 10 Ga. ?
The blank size of sheet metal can be calculated using the bend allowance. This number is based on the metal thickness and the tool radius in the brake.
There is no simple formula to calculate the metal bearing clearance. Manufacturers must specify the clearance for each individual bearing.
Most metal pipes thickness are 25 mm
we can weight one sheet and calculate the unit weight we can weight one sheet and calculate the unit weight
i dont know this nswer
Metals are conductive, but are not perfect conductors and so they have some electrical resistance. How the resistance of the metal is affected by "thickness" depends on what you mean by thickness. If the electrical current has to flow through a longer piece of metal, then the resistance of the metal to electrical flow would be greater. However, if you take that same length of metal and increase the area of the metal by increasing its "thickness", then the resistance of the metal becomes less.
Sheet metal thickness can be determined by measuring it. Several specialty tools are available to tell how thing the sheet metal is in actual measurement or by guage, a form of measurement that is used for various types of sheet metal thickness.
The thickness of the drink made it hard to swallow.The metal sheeting is not the correct thickness.
ON the cad offset the bend radius from the internal radius of the sheet metal part by 40% of the total sheet thickness,and measure the chord length of the radius. that will be the developed length.
A thickness of wire or metal.