0
What else can I help you with?
How much does a Claire's starter kit cost if the earrings at 22.00?
33
What wiring kit i use for Crunch drive v4300 watt1200 amp?
i would say a 4 gauge kit would be more then enough for it 8 gauge min...
What Wire kit do you use for a 180 watt amp?
18 gauge
Can you remove a body kit on a 1997 camaro rs?
i can remove any body kit for u as long as u got the money and time.......
How much do piercings cost at Claires?
The piercing is free withe the Purches of the Claire's starter Kit And I here the price of the starter kit depends on what Earrings you want Claire's has a website you should look their for more details
How do you bypass ac on 2000 Grand Caravan 3.8?
You remove the ac compressor and install a pulley bypass kit from a part store.You remove the ac compressor and install a pulley bypass kit from a part store.
Whats the Correct pressure in Toyota supra AC?
Based on ambient temperatureBuy a kit with a gauge and instructions
What is the difference between a 4 gauge and 8 gauge amp wiring kit?
Far as I know it's just size of wire, smaller the gauge the thicker the wire. which means the 4 is going to be thicker than the 8.
How do you remove a lowering kit on a 1995 Chevrolet s10?
junk it
How do you repair 1990 Honda civic dx head gasket?
Head gas kit is a seal which seals the compression your engine make. you just remove the head and remove the gas kit and do use any metal as it will ruin your engine.Replace it with you new gas kit.
Where is fuel pressure check port on 1995 Chevy v8 pickup?
There's not 1. They sell a fuel pressure Gauge kit that goes in the line up by the throttle body when you remove the fuel line from it. Nother words you will have to splice into the fuel line.
How can I replace the light kit on my ceiling fan?
To replace the light kit on your ceiling fan, first turn off the power to the fan at the circuit breaker. Remove the old light kit by unscrewing it from the fan. Disconnect the wires and remove the old light kit. Install the new light kit by connecting the wires and screwing it into place. Turn the power back on and test the new light kit to ensure it is working properly.
