0
Yes there most defiantly is.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can head bolts be reused 2.2 cavalier?
you are suppose to replace head bolts they stretch and head will not torque right. When you buy the new gasket, order new bolts.
How much is the torque of 2c cylinder head bolts Toyota?
torque for 2c engine cylinder head bolts
What are the torque specifications of head bolts on a 2.5 L 91 S10 And is it necessary to have the heads checked out when you replace the head gasket?
you don't have to have the head checked but its recommended. the head bolts are supposed to be torqued in counterclockwise order from the inside bolts to the outside bolts. torque them in order in three stages to 18 ft/lbs then to 27 ft/lbs then an additional 120 degrees except the front right stud which you torque to 90 degrees
What is the cylinder head torque sequence for a 1997 ford escort 2.0l?
torque head bolts and order ford 1997 2.0L picture if avalible please
Torque setting for cylinder head bolts for a Skoda felicia?
torque setting for cylinder head bolts for a skoda felicia
What is the torque specs for head bolts on a Chevy 292 straight 6?
Torque for 292 head bolts is 95 ft lbs
What are the cyl. head bolt torque specs for a KIA 1.8 L 2000?
Hello: Install cylinder head bolts. Tighten cylinder head bolts according to following procedure: Tighten cylinder head bolts in order shown, Can not show diagram for this. Tightening torque : 36.1 lb-ft (49N
What is the proper torque setting on head bolts for a 1963 Massey Ferguson model 65 diesel?
massey65 torque head bolts please
To what torque must the bolts on the head of a 2000 Hyundai accent be tightened?
to what torque must the bolts on the head of a 2000 Hyundai accent be tightened?
Torque specs for a 1995 Subaru impreza 2.2 head bolts?
Torque specs for a 1995 subaru impreza 2.2 head bolts?
What is the torque specification for Toyota Camry 1989 four cylinder head bolts?
1991 toyota camry head bolts torque specs
What are the torque specs for 660 raptor head and hex bolts?
The torque specs for 660 raptor head and hex bolts is about 26 lbs.
